2. Avteq
  3. C10-WM

Avteq C10-WM Installation guide

  • Hello! I've reviewed the provided installation drawing for the AVTEQ Cisco Touch 10 Wall mount. This document provides instructions on how to mount the device, including details about how the wall box is attached to the wall stud and how the device itself is fastened to this box. I'm ready to answer any questions you might have about the installation process.
  • How is the wall box attached to the wall?
    Can the wall box be mounted on the top or bottom?
    How is the Cisco Touch 10 case attached to the wall box?
DETAIL A
SCALE 1 / 3
A
1
1
2
2
3
3
4
4
A A
B B
C C
D D
SHEET 1 OF 1
DRAWN
CHECKED
QA
MFG
APPROVED
jrod 8/3/2015
DWG NO
Cisco Touch 10 Wall
TITLE
SIZE
C
SCALE
REV
AVTEQ
THIS DOCUMENT CONTAINS CONFIDENTIAL AND PROPRIETARY
INFORMATION THAT CANNOT BE REPRODUCED OR DIVULGED,
IN WHOLE OR IN PART, WITHOUT WRITTEN AUTHORIZATION FROM
AVTEQ Inc. Dallas TX 75247, (214) 905 9001, AVTEQ.net
(4) 1/4"-20 bolts fasten the Cisco
Touch 10 case to the wall box
The Wall box is fastened to a stud on
either the left or right side via 6 screws.
If a horizontal brace can be added to the
wall the box may be mounted on the
top or bottom.
/