Traceable 4134 Owner's manual

SPECIFICATIONS

Range: –58 to 1999 °F (–50 to 1300 °C)

Resolution: 0.1° or 1° (selectable)

Accuracy: ±0.3% + 1°C

Sampling Rate: 2.5 times per second

Display: 3½digitLCD,⅝incheshigh(1.5cm)

Fail-safe: Low battery indicator

Power: 9 volt alkaline battery

Accessories: Type-Kthermocouple,rubberizedcase

andaip-outstand

FRONT PANEL QUICK REFERENCE

ON/OFF: Turnspoweronandoff

MAX: Recordsandupdatesmaximumvalues

HOLD: “Freezes”thedisplay

0.1°: Selectsresolutionto0.1°

1°: Selectsresolutionto1°

°C/°F: Selectsthetemperaturetobedisplayedineither

FahrenheitorCelsius

OPERATION

Inserttheprobeplugintothereceptaclelocatedonthefront

ofthethermometer.Theplugandreceptaclearekeyedwith

asmallandalargepin.Makecertainthattheplugisinserted

properly.

PresstheON/OFFbuttontoturntheuniton.

Pressthe°C/°Fbuttontodisplaythetemperaturein

Fahrenheit(°Fwillappearonthedisplay)orCelsius(°Cwill

appearonthedisplay).

Setthethermometertodesiredresolution0.1°or1°.

Placetheprobetipincontactwiththematerialtobe

measuredandreadthetemperatureonthedisplay.

MAX MODE

IntheMAXmode,thethermometerwilldisplaythehighest

temperaturereadingachieved.Itdoesnotdisplaythecurrent

temperatureifitfallsbelowtheMAXreading.

Example:IntheMAXmode

PresstheMAXbutton(MAXwillappearonthedisplay).The

thermometerwilldisplaythemaximumtemperaturereading

ontheLCDdisplay.PresstheMAXbuttonagaintoexitMAX

recording mode.

HOLD

PresstheHOLDbuttonto“freeze”thedisplayatthecurrent

reading(HOLDwillappearinthedisplay).PresstheHOLD

buttonagaintoreturntothecurrentreading.

PROBES

Theprobesuppliedareultra-fastresponseType-K

thermocouplenakedbeadprobeswith4’leadsandteon

insulation.Maximumoperatingtemperaturerangeforthis

thermocoupleis500°F(260°C).

Anaccessorystainlesssteeltriplepurposeprobewithhandle

isavailable.Anaccessorysurfaceprobeisalsoavailable

(see accessories).

Longerleadsandextensionmaybeused.Theleadeffectfor

164feet(50meters)isgenerallylessthe0.2°Cwithalimit

oferrorof2.2°C.Type-KwireandType-Kconnectorsmust

beused.

RECORDER OUTPUT

Avoltageproportionaltothedisplayreadingappearsatthe

recorderOUTPUTsocketlocatedontherightsideofthe

unit.Outputisviaastandard3-pole3.5mmjack.

Output specications are as follows:

1mVoutputperdegreeinthe0.1°displaymode

0.1mVoutputperdegreeinthe1°displaymode

Output examples:

OFFSET ADJUSTMENT (Fine tuning)

Theoffsetcontrolsaresetatthefactorytoallowforthe

variationsfoundinstandardthermocouples.Byadjusting

theoffsetcontrols,foundonthesideoftheunit,you

canoptimizemeasurementaccuracyforaparticular

thermocoupleataparticulartemperature.

ThisunithasbeencalibratedTraceable

to standards

providedbytheNationalInstituteofStandardsand

Technology(NIST).Whileoffsetadjustmentsare

possible,theywillinterferewiththefactorycalibration.

Traceable

recalibrationmustbemadebythefactory(see

Recalibration).

BENCH STAND/WALL MOUNT

Thisunitissuppliedwithabenchstandthatisonthebackof

thecase.Locatetherectangularslotsontheraisedportion

ofthebackoftheunit.Withyourthumbandforenger,liftthe

standout.Toclosethestand,simplysnapitshut.

Thisunitmaybewallmountedbyusingascrew.Setthe

screwintothewallatthelocationdesired,theheadofthe

screwwillneedtoslipintothereceptacleonthebackof

theunit,sodonotsetthescrewushtothewall.Oncethe

screwhasbeenproperlyset,hangtheunitinplacebysliding

thereceptacleonthebackoftheunitovertheheadofthe

screw.

CURRENT TEMPERATURE DISPLAY READS

42° 42°

60° 60°

40° 60°

Mode Readings Output

0.1° 26.5° 26.5mV

1° 1500° 150.0 mV

2016

Control Company. 92-4134-00 Rev. 1 061316

ACCESSORIES

Control Cat. No. 4014—

StainlessSteelTriplePurposeProbe,probediameter

"(0.32cm),probelength6"(15.2cm),overalllength9"

(22.9cm),cablelength50"(127cm).

Control Cat. No. 4008—

SurfaceProbe,atdiskonendhasadiameterof0.39"

(1cm),overalllength9"(23cm),cablelength36"(91.4cm).

Control Cat. No. 4028—

Ultra-fastresponse,nakedbeadthermocouple.(identicalto

probesuppliedwithunit)cablelength48"(122cm).

Control Cat. No. 8039—

Low-TemperatureProbe-Stainless-steelwithhandle;triple

purpose(liquids,air/gas,andsemi-solids),Dimensions:

diameter0.17inch;stemlength12inches;overalllength17

inches.

Control Cat. No. 8613—

High-TemperatureProbe-Ten-foot-long0.19-inchdiameter

braidedmetalwirecablewithsmoothtipmeasures-73to

982°Ccontinuousor1093°Cshort-termuse.

DISPLAY MESSAGES

OLindicatesthatnoprobeispresent

indicatesthatthebatteryislowandneedsreplacement

(see batter replacement).

ALL OPERATIONAL DIFFICULTIES

Ifthisthermometerdoesnotfunctionproperlyforanyreason,

pleasereplacethebatterywithanewhighqualitybattery

(see“BatteryReplacement”section).Lowbatterypowercan

occasionallycauseanynumberof“apparent”operational

difculties.Replacingthebatterywithanewfreshbatterywill

solvemostdifculties.

BATTERY REPLACEMENT:

A“ ”symbolwillappearontheLCDdisplaywhenthe

batteryneedsreplacement.Beforereplacingthebatteryturn

theunitoffandunplugtheprobe.Removethethreescrews

fromthebackofthethermometerandliftoffthebackof

thecase.(NOTE:Whenthetopmiddlescrewisremoved,

the2-piecestandwithcomeoffthecase).Removethe

exhaustedbatteryandreplaceitwithanew9-coltalkaline

battery.Replacethebackofthethermometer,replacethe

2-piecestand,reinstallthethreescrewsandtightensecurely.

WARRANTY, SERVICE, OR

RECALIBRATION

For warranty, service, or recalibration, contact:

CONTROL COMPANY

12554 Old Galveston Rd. Suite B230

Webster, Texas 77598 USA

Ph. 281 482-1714 • Fax 281 482-9448

E-mail [email protected]

www.traceable.com

Control Company is ISO 9001:2008 Quality-Certied

by DNV and ISO/IEC 17025:2005 accredited as a

Calibration Laboratory by A2LA.

TRACEABLE

DIGITAL

THERMOMETER

WITH RECORDER

OUTPUT

INSTRUCTIONS

Traceable

is a registered trademark of Control Company.

Traceable 4134 Owner's manual

Related papers

Other documents