EGB001-4x2
Raised Garden
Bed Planter
Thank you for purchasing the
ecoConcepts™ Raised Garden
Bed Planter from New Age
Garden, the leading brand in
the eco-friendly garden
products. All ecoConcepts
products are made of
ecoFLEX™, a composite of
recycled polymers and wood
by products. In addition to
being eco-friendly, these
products possess of the best
qualities of the polymers and
the wood. The appealing wood
look easily matches other
garden furniture. The polymer
resin protects the product from
moisture and insects and make
it will look great for years!
Other ecoConcepts™ products
Available:
• 4’ x 4’ Garden Bed /
Sandbox
• Planters in a variety of
sizes
• Sand box cover (4’x4’)
• Dog Houses
• Chicken Coops
• Rabbit Hutches
Visit our websites for more:
www.NewAgeGarden.net
www.newagepet.com
25063 Viking Street
Hayward, CA 94545
Toll Free: (877) 345-3623
Outside US (510) 887-5976
Email: info@NewAgePet.com
Painting / Staining Instruction
Painting: Before the planter is assembled, prime all surfaces that you want to paint with a primer
that is to be used with exterior latex paint. Priming is not a requirement but it is highly recommended
as it will provide better coverage when you apply the paint and you paint job will last longer and look
better.
After the primer has dried – check the instructions on the primer to determine the time between
application of the primer and when it is ready for paint – apply a minimum of 2 coats of a quality
exterior latex based primer.
Allow the panels to dry completely and reassemble the house and that’s it!
Staining:
Before the planter is assembled, apply a coat of quality oil based stain to the panels.
Let the stain set for about 5-7 minutes and wipe off the excess stain. If the color is lighter than the
effect you are looking for, repeat until you get the color you want. The base and top trim might take
longer time and more coat to get to the desired color.
Let the stain dry thoroughly – check the instructions on the stain to determine full drying time – and
then apply a minimum of 2 coats of a polyurethane varnish/top coat. Using a poly with additional UV
inhibitors in the poly will add to the time required before you will need to retain the planter.
EASY ASSEMBLY
1
2
3
4
5
Stainless
steel pins
Corner
Post (4)
Side
Panels (4)
Insert the pins on the ends
of the side panel into the
corresponding keyhole
slots in the corner posts
Repeat adding a 2
nd
corner post and then
a 2
nd
panel and the
3
rd
corner post.
Add the 3
rd
side
panel and the 4
th
corner post
Complete by
adding the 4
th
side panel.
Ready to plant
6
/
