LMP Slide Rails
LMP Slide Rails for LMP iRack 100 & 120, 550 - 615 mm
Contents:
• 4x Metal Bracket
• 2x Rack Slide Rail
• 10x Screw short (5 mm)
• 10x Screw long (8 mm)
• 10x Nut
• 10x Washer
Material needed (not included):
• Screwdriver for recessed head screws (PH2)
• 8x Rack Nut
• 8x Rack Screw
Attention! The two slide rails must be separated before you start the installation. The inner slide rail
must be seperated from the outer (see below).
4x Metal Bracket
8x Rack Screws (not included)
8x Rack Nut (not included)
Attach the four metal bracket to the rack at the
desired position. You may use two screws and
nuts for each bracket to attach it rmly (not
included).
2x Rack Slide Rails (outer Slide Rails)
Insert the two outer slide rails to the brackets.
1
2
3
Important! Make sure that the outer slide rail
is mounted at the very end of the Bracket as
shown in the picture (needed at the front
bracket only).
2x Screws (8 mm)
2x Washer
2x Nut
Attach the Slide Rail with an 8 mm screw to the
bracket.
Important! The screw‘s head must face inwards
as shown in the picture!
2x Screws (8 mm)
2x Washer
2x Nut
4x Screw (5 mm)
Attach the inner slide rail to the LMP iRack as
shown in the picture. Use the screws 5 mm.
4
5
6
7
Make sure that the slide rail is attached at the
very top (up to the iRack‘s bracket).
Info: When installing the LMP iRack for the rst
time, you may have to overcome a resistance.
Push the LMP iRack to the back.
Slide Rail safety lock .
To fully remove the LMP iRack, you must unlock
the safety lock by pushing inwards with a nger
on the safety lock. You may pull the LMP iRack
out of the rack.
8
9
10
11
LMP iRack safety locks.
To open the lid of the LMP iRack, you must un-
screw the ve screws as shown in the picture.
After opening the lid, you have full access to the
inner part of the LMP iRack. You may perform
any service on your Mac mini now.
Info: Be aware that the length of the cables in
the back of the LMP iRack should be at least 0.5
m.
12
13
14
15
/