PMP7880D3G_DUO EN - 1
1. Packing List
1. Prestigio MultiPad
2. AC Adapter
3. Carrying Case
4. USB Cable
5. Quick Start Guide
6. Warranty Card
7. Legal and Safety Notices
8. OTG Cable
9. Electromagnetic Pen
2. Device Overview
Quick Start Guide
Prestigio MultiPad
PMP7880D3G_DUO
EN
11
10
9
1
8
10
2
7
4
3
11
13
5
6
12
EN – 2 PMP7880D3G_DUO
Power
Turn on/off the device; Suspend/Activate
the device
DC port
AC adapter connection.
HDMI Port
HDMI cable connection.
USB port
USB connection
Micro SD Card Slot
Insert the Micro SD card
SIM Card Slot
Insert SIM Card
Earphone Jack
Earphones connection.
Rear Camera
Take photos
Front Camera
Take photos or video chat
Vol +\ Vol -
Adjust the volume level
Reset
Reset the device if it fails to operate
correctly
Switch
Turn on/off Capacitive touch
Built-in Microphone
Record sounds
Getting Started
3. Charging
Insert the connector of adaptor to the DC port on the device and
connect the power adapter to the wall socket for charging.
Normally it takes approximately 5 hours to fully charge the device.
Operating the device while charging with the AC adapter may extend
the time of full charging.
Notice: The device cannot be charged via USB.
10
8
9
7
6
5
4
3
2
1
EN
Quick Start Guide
Prestigio MultiPad
PMP7880D3G_DUO
11
12
13
PMP7880D3G_DUO EN - 3
4. Power on/Power off
Press and hold the Power Button to turn on the device. It will
automatically enter the Home screen after the start-up screen.
Press the Power Button once to enter sleep mode and press it again
to awake the device.
Press and hold the Power Button, and then tap on OK button to
power off the device.
5．Inserting a Memory Card/ SIM Card
a. Insert SD card
The device supports micro SD/SDHC cards.
To insert a Micro SD card, place the card connector towards the rear
side of the device and the printing side of the card towards the front
side of the device.
To remove the micro SD card, gently press the edge of the card to
release the safety lock and pull the card out of the slot.
Notice: When you are reading the file from micro SD card, please
don’t remove it, otherwise the device could fail to operate correctly.
b. Insert SIM card
To insert a SIM card, place the metal side of SIM card towards the
EN
Quick Start Guide
Prestigio MultiPad
PMP7880D3G_DUO
Open
Open
EN – 4 PMP7880D3G_DUO
back side of the device and the triangular cut of the card will be
insterted into the device.
To remove the SIM card, gently press the edge of the card to release
the safety lock and pull the card out of the slot.
Notice:
1. Don’t insert or remove the SIM card while the device is on. Please
insert or remove the SIM card while the device is off
2. The device support 3G (only WCDMA) card
Technical Specifications
Processor
Dual Core ARM Cortex A9 up to 1.6 GHz
RAM
1GB DDR3
Display
8” IPS Electromagnetic panel, Capacitive
multi touch
Resolution
1024 x 768 pixels
Storage capacity
16 GB flash memory (about 14 GB are
accessible by user), Memory card slot
supports micro SDHC card up to 32 GB
Interfaces
USB 2.0, Micro SD (micro SDHC compatible),
SIM
Communications
Wi-Fi (802.11 b/g/n)
Battery
6000 mAh Li-Polymer battery
Dimensions
207x164x11.5mm (L x W x H)
Weight
565 g
Operation
Temperature
0℃ ～ +45℃
Disclaimer
1. As the Prestigio products are constantly updated and improved, your
device’s software may have a slightly different appearance or modified
functionality than presented in this Quick Start Guide.
2. Do not expose the pouch with the device inside to temperatures
exceeding 45 ℃. The pouch may be pulled out of shape.
EN
Quick Start Guide
Prestigio MultiPad
PMP7880D3G_DUO
/
