A Standex Company
MODELS: □ HR-20 □ HR-31 □ HR-45 □ HR-50 □ HR-75 □ HR-85
MODELS: □ HRS-20 □ HRS-31 □ HRS-45 □ HRS-50 □ HRS-75 □ HRS-85
PRODUCT: QUANTITY: ITEM #:
APW Wyott Foodservice Equipment Company · 729 Third Ave., Dallas, TX 75226 Rev. 11/10/11bd
(800) 527-2100 · (214) 421-7366 · Fax (214) 565-0976 · www.apwwyott.com· [email protected]
X*PERT™ Series HotRod
®
Roller Grill
Flat Surface Roller Grill
Designed Smart
Equipment Packages to fit your Operations!
Available in a variety of sizes to fit your counter space:
• Compact HR(S)-20 (11 roller & 13” cooking surface across)
• Regular size HR(S)-31 (11 rollers & 19 ½” cooking surface across)
• Full Menu Size HR(S)-50 (11 rollers & 30 ½” cooking surface
across) and HR(S)-85 (18 rollers & 34” cooking surface across)
• Available in Chrome or “Tru-Turn” textured rollers.
• Unit is designed to be used in a “clerk served” operation or in a
customer “self-serve” merchandising plan. For counters between
clerk and customer, the Flat Roller Grill is available with reversible
“rear controls” and a “pass-through” sneeze guard.
Designed to Deliver Great Tasting Hot Dogs!
Roller Grill heats quickly and has a fast recovery.
• Heating system has two cooking zones that can be turned to
Grilling temperatures for cooking Hot Dogs in less than 4 minutes*
and turned down to NSF-safe holding temperatures for serving
customers.
• HR(S)-20 flat equipment can grill 340 Hot Dogs per hour.
• HR(S)-31 flat equipment can grill 510 Hot Dogs per hour.
• HR(S)-50 flat equipment can grill 850 Hot Dogs per hour.
*Grill times based on Pre-heated roller grill (about 10 minutes warm up cycle)
Easy to Operate and Maintain!
“Easy to read” graphics and heavy duty knobs on the control panel
make it easier for employees to operate at the correct temperatures.
• Infinite Control System gives operator the maximum ability to
adjust temperatures to a variety of hot dogs, sausage, egg roll, or
other roll type products.
• Roller Grill is designed to require minimal labor:
• “Tru-Turn” coated rollers just wipe clean with damp rag.
• Raised rollers allow cleaning in “hard to reach” areas.
• Removable grease collection pan is simple to clean.
• Easiest Roller Grill in the Industry to service:
• Unit is supplied with “easy to remove” side and bottom panels.
• Dependable, high torque motor is one of the most dependable in
the industry.
Design Features
• Exterior cabinet constructed of stainless steel for maximum
durability.
• “Tru-turn” coating is 30% thicker than competitive non-stick
coatings.
• Teflon seals at end of rollers stop grease from migrating into
motors and chains.
Model: HR-50 Roller Grill
X*PERT™ Series
• New Patent Pending Bearing Design -Bearing is Larger, Wider
Radius, Tougher Material and has more surface contact area.
Provides more roller tube and metal gear sprocket support.
Eliminates wear, wobble and more than doubles overall bearing
life thus providing more years of dependable operation.
• Tru-Turn roller system enhancements include improved metal gear
sprockets, design improvements on the Self Aligning Chain
Guide/Tension System to provide noise free and smooth chain
operation along with eliminating chain slippage.
• Tru-Turn roller tube coating processes have been enhanced to
provide the thickest coating in the industry (measured by mil
thickness and over 30% greater than competitors units) which
provide years of better turning of products, ease of cleaning and a
better looking roller grill.
• Tru-Heat has been enhanced to provide more even heating across
the roller grill surface and maintain a temperature variance of less
than 7 degrees. Tru-Heat eliminates hot spots found in competitors
roller grills which over-heat products and greatly reduce product
hot hold time on the roller grill causing increased waste
Reliability backed by APW Wyott’s
Warranty
All APW Wyott HotRod Roller Grill equipment is backed by a 1-year
parts and labor warranty, including on-site service calls within 50
miles of authorized service technicians.
See reverse side for product specification
A Standex Company
MODELS: □ HR-20 □ HR-31 □ HR-45 □ HR-50 □ HR-75 □ HR-85
MODELS: □ HRS-20 □ HRS-31 □ HRS-45 □ HRS-50 □ HRS-75 □ HRS-85
PRODUCT: QUANTITY: ITEM #:
APW Wyott Foodservice Equipment Company · 729 Third Ave., Dallas, TX 75226 Rev. 11/10/11bd
(800) 527-2100 · (214) 421-7366 · Fax (214) 565-0976 · www.apwwyott.com· [email protected]
X*PERT™ Series HotRod
®
Roller Grill
Flat Surface Roller Grill
Construction:
Stainless steel exterior, aluminum drip pan and coated steel bottom.
Chrome or “Tru-Turn” textured rollers (specify Model HRS-20, -31
or -50 for “Tru-Turn”. Heavy duty high torque motor.
Shipping Weight:
HR(S)-20: 35 lbs (15.9 kg)
HR(S)-31: 44 lbs (19.1 kg)
HR(S)-45: 46 lbs (21 kg)
HR(S)-50 : 55 lbs (25 kg)
HR(S)-75: 87 lbs (39.1 kg)
HR(S)-85 : 89 lbs (40 kg)
FOB: Cheyenne WY 82007
Accessories & Options:
4” Metal Leg Kit
Reversible Controls (add R to model type)
Pass through Sneeze Guards
6” Tongs
Divider Kits
Polycarbonate Sneeze Guards
S=TruTurn coating on roller tubes
BW=Bun Warmer, heated bun drawer
BD=Unheated Bun drawer
R=Reverse controls on back of unit (available only on slant models)
W=Wide spacing for bigger products
Electrical Information:
120V units use a 5-15P plug. Both the 208V and 240V units
are provided with a 60” power cord with a Nema 6-15P plug
that exits from the bottom on the left rear corner.
HR(S)-20: 120V, 768W, 6.4 Amps, 60Hz
HR(S)-31: 120V, 985W, 8.3 Amps, 60Hz
208V/240V, 885/1160W, 3.2/4.8 Amps
220V, 990W, 4.5 Amps
HR(S)-45: 120V, 1465W, 12.2 Amps, 60Hz
120V (Two power cords)
HR(S)-50: 120V, 1320W, 11 Amps, 60Hz
208/240V, 1260/1665W, 6.2/7 Amps
HR(S)-75: 208V, 1820W, 8.9 Amps
985W, 8.3 Amps, 60Hz, 1 phase
240V, 2410W, 10.1 Amps
HR(S)-85 208V, 2017W, 9.7 Amps
240V, 2640W, 11 Amps
Overall Dimension:
HR(S)-20: 8 1/2”H x 17 ¼”W x 18 5/8”D
(21.6 cm x 43.8 cm x 47.3 cm)
HR(S)-31: 8 1/2”H x 23 ¾” W x 18 5/8”D
(21.6 cm x 88.3 cm x 47.3 cm)
HR(S)-45: 8 1/2”H x 23 ¾” W x 29 9/16”D
(21.6 cm x 60.3 cm x 75.1 cm)
HR(S)-50: 8 1/2”H x 34 ¾”W x 29 9/16”D
(21.6 cm x 88.3 cm x 75.1 cm)
HR(S)-75: 8 1/2”H x 34 ¾”W x 29 9/16”D
(21.6 cm x 88.3 cm x 75.1 cm)
HR(S)-85: 8 1/2”H x 34 ¾”W x 29 9/16”D
(21.6 cm x 88.3 cm x 75.1 cm)
NOTE: 7/16” space between rollers.
*APW Wyott Reserves the right to modify specifications or
discontinue models without incurring obligation.
-
1
-
2
