Southbend HDG-36-RE Datasheet

  • Hello! I am an AI chatbot trained to assist you with the Southbend HDG-36-RE Datasheet. I’ve already reviewed the document and can help you find the information you need or explain it in simple terms. Just ask your questions, and providing more details will help me assist you more effectively!
Job Item#
www.yatesgd.com www.yatesgraphicdesign.com
Counterline - Griddle
Heavy Duty, Thermostatic, Gas
Standard Features
- Availablein24”,36”,48”,60”and72”widths
- 30,000BTU(NATorLP)burnerper12”
- Electronicsparkignition(battery)
- Stainlesssteelfront,ventandsidesarestandard,rearand
bottompanelsarealuminizedsteel.
- Reinforced,insulateddoublewallsides
- 1”thickpolishedrolledsteelplate
- 5”highrearandsidesplashguards
- Flamefailuresafetydevice
- 3/4”reargasconnectionandpressureregulator
- Protectedueopening
- “Insta-on”thermostaticcontrolsforprecisesettingsbetween
150°Fand400°F
- Imbeddedloadsensingthermostat
- Exclusive“NOCOLD”Zone-Uniformheatdistributionacross
surface
- Eachburnerequippedwithrunnertube
- 4”Spatulawidthfrontgreasetrough
- Optional3”reargreasetroughcombinedwith2-5/8”front
greasetrough,availableon36”,48”and60”.(doesnot
reduce24”griddledepth)
- Hiddengreasedrawerswithlargecapacity
- Fullyweldedgriddleplatewithprotectedexhaustvent
(Model HDG-24)
PrintedinUSA
HDG-24, HDG-36, HDG-48, HDG-60, HDG-72
HDG-36-RE, HDG-48-RE, HDG-60-RE
FormHDGRev6(June/2010)
STANDARD CONSTRUCTION SPECIFICATIONS
Exterior Finish:Front,sidesandventareconstructedof#3
polished 430 and 304 stainless steel. Bottom and rear are
aluminizedsteel.Sidesarereinforcedandfullyinsulated.5”
rearandsidesplash.
Griddle Plate: 24”,36”,48”,60”,72”wideunitwithtwo15,000
BTU (NAT or LP) burners every 12”. Fully welded, 1” thick
polishedsteelgriddleplatewithsidesplashguards,andgrease
drawer.
Griddle Controls:Independent,“Insta-on”thermostaticcontrols
withuniformtemperaturerangeof150°Fto400°F.
Legs:Stainlesssteel4”adjustablelegs.
Gas Heat Control System:Eachfootofgriddleisheatedbya
“U”shapedburner.Eachburneriscontrolledbyathermostatic
controlandisequippedwithanindependentpilot.Forsafety,
eachpilothasaamefailuredevice.A3/4”reargasconnectionis
standard.Unitsover48”wideareconstructedoftwobodies.
1100 Old Honeycutt Road, Fuquay-Varina, NC 27526
(919) 762-1000 www.southbendnc.com
Models:
29.44" (748)
31.75" (806)
15.25"
(387)
10"
(254)
16.125"
(410)
1.75"
(44)
29.86"
(759)
2" (806)
24"
(610)
WIDTH
5.25" (133)
3" (76)
11" (279)
HDG-24 HDG-36 HDG-36RE HDG-48 HDG-48RE HDG-60 HDG-60RE HDG-72
INTENDED FOR COMMERCIAL USE ONLY.
NOT FOR HOUSEHOLD USE.
FormHDGRev6(June/2010)
Stainlesssteelstand
Stainlesssteelplateshelfwithor
withoutcuttingboard
OPTIONS AND ACCESSORIES
Castersforstand
Groovedgriddleplates
Chromeplatedgriddleplates
UTILITY INFORMATION
GAS: Each unit has a 3/4” rear
gas connection with a male NPT
conn ec to r. Mini mu m su pp l y
pressureis7”W.C.fornaturalgas
and11”W.C.forpropane.Allunits
require a regulated gas supply.
pressureregulatorincluded.Ifusing
aexiblehosegasconnection,the
I.D.ofthehosemustnotbesmaller
thantheconnectorontheunitand
must comply with ANSI Z21.69,
providing an adequate means of
restrainttopreventunduestrainon
thegasconnection.
MISCELLANEOUS
- Ifcastersareusedwithexhose,arestrainingdevice
shouldbeusedtoeliminateunduestainontheex
hose.
- Minimumclearancefromnoncombustibleconstruction
iszero.Minimumclearancefromcombustible
constructionis10”onsidesand6”onrear.
- Installunderventedhood.
- Checklocalcodesforreandsanitaryregulations.
NOTICE:
Southbendhasapolicyofcontinuousproductresearch
andimprovement.Wereservetherighttochange
specicationsandproductdesignwithoutnotice.Such
revisionsdonotentitlethebuyertocorresponding
changes,improvements,additionsorreplacementsfor
previouslypurchasedequipment.
2”highinsulatorbaseformounting
onrefrigeratedbase
3”Reargreasetroughavailableon
36”,48”and60”models
StandardFrontGreaseTroughDimensions
OptionalRear/FrontGreaseTroughDimensions
Shipping Crate DimenSionS & Weight
moDel WiDth
BurnerS
@30,000
Btu
CrateD
WiDth
CrateD
Depth
CrateD
Weight
HDG-24
24”
(610)
2
31”
(788)
39”
(991)
305lbs
(159kg)
HDG-36/
HDG-36-RE
36”
(915)
3
55”
(1398)
39”
(991)
445lbs
(202kg)
HDG-48/
HDG-48-RE
48”
(1220)
4
55”
(1398)
39”
(991)
545lbs
(247kg)
HDG-60/
HDG-60-RE
60”
(1525)
5
67”
(1703)
45.5”
(1157)
705lbs
(320kg)
HDG-72
72”
(1830)
6
110”
(2796)
45.5”
(1157)
840lbs
(378kg)
moDel
gaS (Btu/hr)
natural propane
HDG-24 60,000 60,000
HDG-36/
HDG36-RE
90,000 90,000
HDG-48/
HDG-48-RE
120,000 120,000
HDG-60/
HDG-60-RE
150,000 150,000
HDG-72 180,000 180,000
/