Southbend HDG-24 Datasheet

Southbend
Brand
Southbend
Model
HDG-24
Category
Electric griddles
Type
Datasheet
Job Item#
www.yatesgd.com www.yatesgraphicdesign.com
Counterline - Griddle
Heavy Duty, Thermostatic, Gas
Standard Features
- Availablein24”,36”,48”,60”and72”widths
- 30,000BTU(NATorLP)burnerper12”
- Electronicsparkignition(battery)
- Stainlesssteelfront,ventandsidesarestandard,rearand
bottompanelsarealuminizedsteel.
- Reinforced,insulateddoublewallsides
- 1”thickpolishedrolledsteelplate
- 5”highrearandsidesplashguards
- Flamefailuresafetydevice
- 3/4”reargasconnectionandpressureregulator
- Protectedueopening
- “Insta-on”thermostaticcontrolsforprecisesettingsbetween
150°Fand400°F
- Imbeddedloadsensingthermostat
- Exclusive“NOCOLD”Zone-Uniformheatdistributionacross
surface
- Eachburnerequippedwithrunnertube
- 4”Spatulawidthfrontgreasetrough
- Optional3”reargreasetroughcombinedwith2-5/8”front
greasetrough,availableon36”,48”and60”.(doesnot
reduce24”griddledepth)
- Hiddengreasedrawerswithlargecapacity
- Fullyweldedgriddleplatewithprotectedexhaustvent
(Model HDG-24)
PrintedinUSA
HDG-24, HDG-36, HDG-48, HDG-60, HDG-72
HDG-36-RE, HDG-48-RE, HDG-60-RE
FormHDGRev6(June/2010)
STANDARD CONSTRUCTION SPECIFICATIONS
Exterior Finish:Front,sidesandventareconstructedof#3
polished 430 and 304 stainless steel. Bottom and rear are
aluminizedsteel.Sidesarereinforcedandfullyinsulated.5”
rearandsidesplash.
Griddle Plate: 24”,36”,48”,60”,72”wideunitwithtwo15,000
BTU (NAT or LP) burners every 12”. Fully welded, 1” thick
polishedsteelgriddleplatewithsidesplashguards,andgrease
drawer.
Griddle Controls:Independent,“Insta-on”thermostaticcontrols
withuniformtemperaturerangeof150°Fto400°F.
Legs:Stainlesssteel4”adjustablelegs.
Gas Heat Control System:Eachfootofgriddleisheatedbya
“U”shapedburner.Eachburneriscontrolledbyathermostatic
controlandisequippedwithanindependentpilot.Forsafety,
eachpilothasaamefailuredevice.A3/4”reargasconnectionis
standard.Unitsover48”wideareconstructedoftwobodies.
1100 Old Honeycutt Road, Fuquay-Varina, NC 27526
(919) 762-1000 www.southbendnc.com
Models:
29.44" (748)
31.75" (806)
15.25"
(387)
10"
(254)
16.125"
(410)
1.75"
(44)
29.86"
(759)
2" (806)
24"
(610)
WIDTH
5.25" (133)
3" (76)
11" (279)
HDG-24 HDG-36 HDG-36RE HDG-48 HDG-48RE HDG-60 HDG-60RE HDG-72
INTENDED FOR COMMERCIAL USE ONLY.
NOT FOR HOUSEHOLD USE.
FormHDGRev6(June/2010)
Stainlesssteelstand
Stainlesssteelplateshelfwithor
withoutcuttingboard
OPTIONS AND ACCESSORIES
Castersforstand
Groovedgriddleplates
Chromeplatedgriddleplates
UTILITY INFORMATION
GAS: Each unit has a 3/4” rear
gas connection with a male NPT
conn ec to r. Mini mu m su pp l y
pressureis7”W.C.fornaturalgas
and11”W.C.forpropane.Allunits
require a regulated gas supply.
pressureregulatorincluded.Ifusing
aexiblehosegasconnection,the
I.D.ofthehosemustnotbesmaller
thantheconnectorontheunitand
must comply with ANSI Z21.69,
providing an adequate means of
restrainttopreventunduestrainon
thegasconnection.
MISCELLANEOUS
- Ifcastersareusedwithexhose,arestrainingdevice
shouldbeusedtoeliminateunduestainontheex
hose.
- Minimumclearancefromnoncombustibleconstruction
iszero.Minimumclearancefromcombustible
constructionis10”onsidesand6”onrear.
- Installunderventedhood.
- Checklocalcodesforreandsanitaryregulations.
NOTICE:
Southbendhasapolicyofcontinuousproductresearch
andimprovement.Wereservetherighttochange
specicationsandproductdesignwithoutnotice.Such
revisionsdonotentitlethebuyertocorresponding
changes,improvements,additionsorreplacementsfor
previouslypurchasedequipment.
2”highinsulatorbaseformounting
onrefrigeratedbase
3”Reargreasetroughavailableon
36”,48”and60”models
StandardFrontGreaseTroughDimensions
OptionalRear/FrontGreaseTroughDimensions
Shipping Crate DimenSionS & Weight
moDel WiDth
BurnerS
@30,000
Btu
CrateD
WiDth
CrateD
Depth
CrateD
Weight
HDG-24
24”
(610)
2
31”
(788)
39”
(991)
305lbs
(159kg)
HDG-36/
HDG-36-RE
36”
(915)
3
55”
(1398)
39”
(991)
445lbs
(202kg)
HDG-48/
HDG-48-RE
48”
(1220)
4
55”
(1398)
39”
(991)
545lbs
(247kg)
HDG-60/
HDG-60-RE
60”
(1525)
5
67”
(1703)
45.5”
(1157)
705lbs
(320kg)
HDG-72
72”
(1830)
6
110”
(2796)
45.5”
(1157)
840lbs
(378kg)
moDel
gaS (Btu/hr)
natural propane
HDG-24 60,000 60,000
HDG-36/
HDG36-RE
90,000 90,000
HDG-48/
HDG-48-RE
120,000 120,000
HDG-60/
HDG-60-RE
150,000 150,000
HDG-72 180,000 180,000
  • Page 1 1
  • Page 2 2

Southbend HDG-24 Datasheet

Southbend
Brand
Southbend
Model
HDG-24
Category
Electric griddles
Type
Datasheet
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents