Supplemental Assembly Instructions
If you are installing the 52" Rail System on a saw with the Mobile
Base, PLEASE notice the 2 - 8 mm cap screws (A) referred to in Step
#12 of the manual and shown in Fig. 6 on page 3, are used for
assembly purposes only. As you adjust the legs on the Extension
Table the head of the cap screws may fall below the slot in the table
top. This will not effect the performance or stability of your saw.
A
A
DEWALT Industrial Tool Co., 701 East Joppa Road, Baltimore, MD 21286 Copyright 2001 Form #604652
-
1
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI