The RE251 Hidden Panic can arm, disarm, and generate panic signals for the security
system.
Features
• Hidden mounting
• 1-button arming and disarming
• Large, easy to differentiate button
• Mounts in hidden locations via VHB™ tape or screws
• Strong, reliable RF signal
• 4-6 year battery life with Panasonic™ CR2032 battery
Enrollment
• Put the control panel in program mode
Note: refer to the Honeywell control unit installation manual
• Go to Key in Programming
• Press “Add New”
• Change the key type to “1 Button”
• Select a user in the user setting
• Press Serial Number
• Press the intended button
• Wait ve seconds, press the button again
• Wait ve more seconds, press the button a third time
• Verify the Button Key and Loop Number
• Correlate, refer to the diagram
Battery Replacement
• Insert screwdriver to open
• Unscrew circuit board from housing
• Remove old battery and place new CR2032 battery positive side up
Pro Tips
3M VHB Tape works well if the surface is properly prepared and rm pressure is applied for over 10
seconds.
Surface Preparation
• Clean the surface
• Ensure the mounting surface temperature is above 50°F
Use the panel installation guide to verify proper system setup.
RE251 Hidden Panic
Honeywell Compatible
I
N
S
T
A
L
L
G
U
I
D
E
I
Disarm
(Loop 2)
Arm
(Loop 3)
Panic
(Loop 1)
Resolution Compatibles
Insert screwdriver here to open
TRADEMARKS
Alula and Connect+ are trademarks owned by Alula Holdings, LLC.
Honeywell is a trademark of Honeywell International Inc., or its
subsidiaries or afliates.
VHB is a trademark of 3M Company.
Panasonic is a trademark of Panasonic Corporation.
IC NOTICE
This device complies with Industry Canada license-exempt RSS
standard(s). Operation is subject to the following two conditions:
(1) This device may not cause interference, and
(2) This device must accept any interference, including interference
that may cause undesired operation of the device.
Le présent appareil est conforme aux cnr d’Industrie Canada
applicables aux appareils radio exempts de licence. L’exploitation
est autorisée aux deux conditions suivantes:
(1) L’appareil ne doit pas produire de brouillage, et
(2) L’utilisateur de l’appareil doit accepter tout brouillage
radioélectrique subi, même si le brouillage est susceptible d’en
compromettre le fonctionnement.
WARRANTY
Alula will replace non-portable products that are defective in their
rst ve (5) years and all portable products in their rst two (2) years.
FCC NOTICE
This device complies with Part 15 of the FCC rules. Operation is
subject to the following two conditions:
(1) This device may not cause harmful interference.
(2) This device must accept any interference that may be received,
including interference that may cause undesired operation.
Changes or modications not expressly approved by Alula could void
the user’s authority to operate this equipment.
FCC ID: U5X-RE251
Specications
Physical
Housing Dimensions
Weight with Battery
Mounting Fastener
3.0 x 1.2 x 0.52 inches (7.62 x 3.048 x 1.32 centimeters)
.9 ounces (25 grams)
VHB tape (provided)
Environmental
Operating Temperature
Maximum Humidity
0°F to 120°F (-17.7°C to 49°C)
85% non-condensing relative humidity
Sensor Specications
Frequency
Replacement Battery
Nominal Battery Life
Battery Voltage
Transmitted Indications
345 MHz
2032 Lithium/Manganese Dioxide
5 years
3.0 VDC (Nominal)
Supervision
Certication
RE251 FCC, IC
Specications subject to change without notice.
47-00XX-XX • REV A • 2018-07-26
Tech Support Line • (888) 88-ALULA • (888) 882-5852
alula.net
/
