Omnitron Systems Technology FlexPoint Wall-Mounting Kit User manual

Brand
Omnitron Systems Technology
Model
FlexPoint Wall-Mounting Kit
Category
Networking
Type
User manual

This manual is also suitable for

FlexPoint
™
Wall-Mounting Kit
Description
The 4380 FlexPoint Wall-Mounting kit was designed
to attach one FlexPoint module to a wall, back-board or
other flat surface. The 4380 kit includes the following
hardware:
(2) “L” shaped brackets.
(4) Flat head screws, 4-40, 1/4 inch.
(4) Wall mounting screws
Warning:
Before installing a FlexPoint unit, make sure to disconnect
it from its power adapter and to disconnect the power
adapter from the AC power outlet.
Mounting
1. Align the screw threads of the FlexPoint unit with
the holes in the bracket.
2. Attach one “L” bracket on each side of the unit using
two 4-40 flat head screws enclosed with the kit.
User Instructions
3. The FlexPoint with the tab bracket should look as
in the picture below.
4. Attach unit to the desired surface using appropriate
screws (not provided).
5. Follow any installation instructions in the FlexPoint
User Installation guide.
Technical Support:
If you encounter problems in installing or maintaining
this product, contact Omnitron Technical Support:
Phone: (949) 250-6510
Fax: (949) 250-6514
Address: Omnitron Systems Technology, Inc.
140 Technology Drive, #500
Irvine, CA 92618 USA
Email: [email protected]
URL: www.omnitron-systems.com
040-04380-001E 11/07
  • Page 1 1

Omnitron Systems Technology FlexPoint Wall-Mounting Kit User manual

Brand
Omnitron Systems Technology
Model
FlexPoint Wall-Mounting Kit
Category
Networking
Type
User manual
This manual is also suitable for
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents