2. Computers & electronics
  3. Computer components
  4. Chassis components
  5. Mounting kits
  6. Metra
  7. 99-1004
99-1004

Metra 99-1004 Specification

  • Hello! I am an AI chatbot trained to assist you with the Metra 99-1004 Specification. I’ve already reviewed the document and can help you find the information you need or explain it in simple terms. Just ask your questions, and providing more details will help me assist you more effectively!
  • Which vehicles is this kit compatible with?
    What kind of head unit does this kit accommodate?
    What tools are required for installation?
    Which color wires are used for the illumination and dimmer connections?
    Where do I connect the ground wire if a black wire is not present?
INSTALLATION INSTRUCTIONS FOR PART 99-1004
99-1004
KIT FEATURES
• ISO and DIN Head Unit Provisions
A) Radio Housing • B) ISO Brackets • C) Trimplate
KIT COMPONENTS
A
• Phillips Screwdriver • Panel Removal Tool
1-800-221-0932
© COPYRIGHT 2001-2008 METRA ELECTRONICS CORPORA
TION
www.metr
aonline.com
TOOLS REQUIRED:
APPLICATIONS
HONDA
PASSPORT 1998-2002
ISUZU
Amigo 1998-2000
Rodeo 1998-2004
Rodeo Sport 2001-2003
C
B
Kit and Final Assembly - All Vehicles
Dash Disassembly - All Vehicles . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1
TABLE OF CONTENTS
99-1004
DIN Head Unit Mount Radio Provision . . . . . . . . . . .
. . . . . . . . . . . . . . . . . . . . . . . .
2,3,4,5
ISO Head Unit Mount Radio Provision
K
NOWLEDGE IS
P
OWER
Enhance your installation and fabrication skills
by enrolling in the most recognized and
respected mobile electronics school in our
industry.
Log onto www.installerinstitute.com or call
800-354-6782 for more information and take
steps toward a better tomorrow.
ALL VEHICLES
Disconnect the negative battery terminal to prevent an accidental short circuit. Remove
the ashtray and (1) Phillips screw exposed in the ashtray cavity. Remove (4) Phillips
screws securing the factory head unit and disconnect the wiring.
1
99-1004 DASH DISASSEMBLY
2
ALL VEHICLES
Fig. B
* OPTIONAL
Fig. A
ISO HEAD UNITS: Snap the Trimplate into the Radio Housing. Attach the ISO Brackets
to the inner lip of the Housing. Slide the head unit into the radio opening, align the
holes in the head unit with the holes in the ISO Brackets and mount the unit to the
brackets with the screws supplied with the unit.
(See Fig. A).
DIN HEAD UNITS: Slide the DIN cage into the Housing and secure by bending the metal
locking tabs down. Slide the aftermarket head unit into the cage and secure. Snap the
*Trimplate into the Radio Housing. (See Fig. B)
99-1004 KIT AND FINAL ASSEMBLY
99-1004 FINAL ASSEMBLY
FINAL ASSEMBLY
(A) Strip wire ends back 1/2"
B)
Twist ends together
C) Solder
D) Tape
A
B
C
D
Locate the factory wiring harness in the dash. Metra recommends using the
proper mating adapter and making connections as shown. (Isolate and individ-
ually tape off the ends of any unused wires to prevent electrical short circuit.)
Re-connect the negative battery terminal and test the unit for proper operation.
Reassemble radio and dash assemblies in reverse order of disassembly.
1
2
3
FINAL WIRING CONNECTIONS
Make wiring connections using the EIA color code chart shown below and the instructions included with the
head unit. Metra recommends making connections as shown below; Strip, Splice, Solder, Tape. Isolate and
individually tape off ends of any unused wires to prevent electrical short circuit.
METRA / EIA WIRING CODE
12V Ignition / Acc. . . . . . . . . . Red
12V Batt / Memory. . . . . . . . . Yellow
Ground. . . . . . . . . . . . . . . . . . Black*
Power Antenna. . . . . . . . . . . . Blue
Amp Turn-On . . . . . . . . . . . . . Blue / White
Amp Ground. . . . . . . . . . . . . . Black / White
Illumination . . . . . . . . . . . . . . Orange
Dimmer . . . . . . . . . . . . . . . . . Orange / White
Right Front (+) . . . . . . . . . . . . Gray
Right Front (-). . . . . . . . . . . . . Gray/ Black
Left Front (+) . . . . . . . . . . . . . White
Left Front (-). . . . . . . . . . . . . . White / Black
Right Rear (+) . . . . . . . . . . . . Violet
Right Rear (-) . . . . . . . . . . . . . Violet / Black
Left Rear (+)
. . . . . . . . . . . . .
Green
Left Rear (-) . . . . . . . . . . . . . . Green / Black
*NOTE: When a Black wire is not present, ground radio to vehicle chassis.
All colors may not be present on all leads due to manufacturer’
s specifica
tions.
3
ALL VEHICLES
"A"
4
Locate the (4) mounting positions in the sub-dash ("A").
99-1004 KIT AND FINAL ASSEMBLY
ALL VEHICLES
5
Re-connect the battery terminal and test the unit for proper operationt. Mount the head
unit/kit assembly to the sub-dash with (4) Phillips screws previously removed on page 1.
99-1004 KIT AND FINAL ASSEMBLY
99-1004 INSTRUCTIONS
1-800-221-0932
REV. 11/26/08 © COPYRIGHT 2001-2008 METRA ELECTRONICS CORPORA
TION INST99-1004
www.metraonline.com
/