Human Touch Indoor Furnishings Massage Chair User manual

Brand: Human Touch

Model: Indoor Furnishings Massage Chair

Type: User manual

REMOVE THE BACKREST FROM THE CHAIR BASE

1. Disconnect all cables that connect the backrest to the left-hand side

of the chair base (Fig.1).

2. Remove the two screw knobs from the bottom of the backrest (Fig.2).

3. Lift backrest off the chair base (Fig.2).

Tools Required: 5/32" (4mm) Allen key, Phillips-head screwdriver.

NOTE: SAVE SCREW KNOBS FOR USE DURING REASSEMBLY.

REPLACING THE BACKREST

HT-7450

06/01/08

(Fig.2)

Screw knob

Backrest

Chair base

(Fig.1)

To ensure that Human Touch

products are repaired in a manner that is fully consistent with the practices used during the manufacturing process, Human Touch requires that all

product repairs are performed using only factory-new parts and in accordance with these product repair instructions.

SERVICE LEVEL: 2

Please send any questions or comments regarding these instructions to:

[email protected]

, LLC.

INSTALL THE BACKREST ONTO THE CHAIR BASE

Screw knob

Backrest

Chair base

1. Align the guides on the lower sides of the backrest with the track on the chair base, then slide the backrest firmly onto the chair base (Fig.3).

2. From the bottom of the backrest, install and hand tighten the two screw knobs. Verify that the two screw knobs are installed and tightened before using the chair.

3. Connect all cables that connect the backrest to the left-hand side of the chair base (Fig.4).

(Fig.4)

(Fig.3)

Human Touch Indoor Furnishings Massage Chair User manual

Human Touch Indoor Furnishings Massage Chair User manual

Human Touch Indoor Furnishings Massage Chair User manual

Related papers

Other documents