![](//vs1.manuzoid.com/store/data-gzf/03c714fb829130be721bc0b763d08d42/2/000681466.htmlex.zip/bg6.jpg)
6
secured to the oor.
Use only new hoses to connect
the appliance to the water
supply. Used hoses must
not be used and should be
discarded.
Move the appliance without
lifting it by the worktop.
Connect the water inlet
hose(s) to the water supply
in accordance with the
regulations of your local water
company.
For models dedicated only for
cold water: Do not connect to
the hot water supply.
For models with hot ll: the
hot water inlet temperature
must not exceed 60 °C.
Make sure that the ventilation
openings in the base of
your washing machine (if
available on your model) are
not obstructed by a carpet or
other material.
The supply water pressure
must be in range 0.1-1 MPa.
If you want to place a dryer
on top of your washing
machine, rst contact our
After-Sales Service or your
specialist dealer to verify if
this is possible. This is only
admitted if the dryer is xed
on the washing machine by
using an appropriate stacking
kit available through our After-
Do not use the appliance
outdoors.
This washing machine is
exclusively destined to treat
machine washable laundry in
quantities which are usual for
private households.
INSTALLATION
Installation and repairs must
be carried out by a qualied
technician, in compliance
with the manufacturer’s
instructions and local safety
regulations. Do not repair
or replace any part of the
appliance unless specically
stated in the user manual.
Use protective gloves to
perform all unpacking and
installation operations.
The appliance must be
disconnected from the power
supply before carrying out any
installation operation.
Only activate the appliance
when the installation
procedure has been
completed.
After unpacking the appliance,
make sure that it has not been
damaged during transport. In
the event of problems, contact
the dealer or your nearest
After-sales Service.
During installation, make
sure the appliance does not
damage the power cable.
The appliance must be
handled and installed by two
or more persons.
When installing the appliance
make sure that the four feet
are stable and resting on
the oor, adjusting them as
required, and check that the
appliance is perfectly level
using a spirit level.
Remove the bottom
protection by tilting and
turning the washing machine
on one rear bottom corner.
Make sure that the plastic
part of the bottom protection
(if available on the model)
remains in the packing and
not in the machine bottom.
This is important, as otherwise
the plastic part could damage
the washing machine during
operation.
If the appliance was exposed
to the cold prior to delivery,
keep it at room temperature
for a few hours before
operating.
Do not install your appliance
where it may be exposed to
extreme conditions, such as:
poor ventilation, temperature
below 5°C or above 35°C.
In case of wooden or so-called
“oating oors” (for instance
certain parquet or laminate
oors), place the appliance
on a sheet of plywood at least
60 x 60 cm wide/ deep and
at least 3 cm thick which is