R410A Mini Split Chiller 50Hz MCAC-ATSM-2014-01
6
5. Descriptions of Standard Unit
The air cooled reverse-cycle chillers with axial-flow fans operate with refrigerant fluid and are suitable for
outdoor installation. They are factory tested and site installation is limited to water and electrical
connections.
Structure
Panels and base are made from galvanized steel plate painted with epoxy powder to ensure total resistance
to atmospheric agents. Condensate collection pan as standard.
Compressor
Midea mini split chillers are equipped with Copeland brand high efficiency, reliable and silence digital scroll
compressor, the capacity can be stepless adjusted , the chiller can bring you more comfortable living
condition with less energy consumption. The system has no EMC problem.
Air cooled condenser
Coils
The coils are made from high performance and seamless copper tuber and high surface area aluminum fins
to ensure optimum heat exchange capability. Condenser coil protection grill is standard.
Low noise fan and fan motor
To achieve high efficiency heat exchange, the units are equipped with the high performance axial-flow fans.
The fan is directly driven by weather proof motor to ensure reliable operation, the fan motor is six–pole
electric motor with built-in thermal cut-out.
Evaporator(in the water pump box)
The heat exchanger is made of AISI 316 stainless steel to ensure high heat exchange efficiency, complete
with electric heater and differential pressure switch. The complete heat exchanger is insulated with thermal
insulation closed cell rubber foam to give optimum thermal insulation.
Water pump box
The mini split chillers water pump box are fully integrated and equipped with key hydraulic components such
as expansion tank, water flow switch, plate type heat-exchanger, water circulating pump.
Refrigerant circuit
The refrigerant circuit is factory brazed and evacuated before accurately charged with R410A to ensure
optimum operating requirement. To ensure flawless continuous operation, each refrigerant circuit is
equipped with a carefully sized capillary tube.
Power and control electrical panel
Power and control electrical panel constructed in accordance with IEC 204-1/EN60335-2-40,complete with
compressor contactor, control via “HSW7”control panel.
Emergency stop pushbuttons:
In case system crisis is occur (e.g: Compressor out of control ), press the emergency stop pushbuttons at
once, and turn it clockwise, until crisis is removed.
Optional accessories:
- Removable metal mesh filter.
- Remote keyboard kit.
The above accessories are optional. Consult the relative documentation for assembly instructions and
technical data.