User’s Manual
Optimus
A stroller for disabled children
Issue 04.2015
We are pleased to present to you a stroller for
disabled children called Optimus. The stroller
is designed for children with cerebral palsy
(CP), myelomeningocele, dysfunctions of the
lower limbs and muscular diseases. Due to
the wide functionality of the stroller it can be
easily adapted to the requirements of any
user.
Before using our product, we recommend you
read this manual, which will certainly make
its daily use easier and will keep the stroller
in impeccable condition for a long time.
The manufacturer is not responsible for any injuries of the user or for any product
damage caused by misuse of the stroller or failure to comply with the recommendations
contained in the user’s manual.
The stroller is designed to transport only one child.
The stroller should ride only on a flat, firm ground.
Before each use, check if the stroller is in order.
The stroller can be used only when it is not damaged and all parts are intact.
Never leave your child unattended in the stroller even if the seat belt is fastened and
the stroller brakes are locked.
The brakes must be always locked even if the stroller is on a flat surface.
Do not allow the child to stand on the footrest. It causes the danger of tipping over
and may lead to the child’s injury.
A child seated in the stroller should always wear a properly adjusted seat belt.
While adjusting any parameters of the stroller, the child should not be in the stroller.
While the child is getting into or out of the stroller, the stroller brakes must be
absolutely locked.
The stroller is not suitable for climbing up or down the stairs. If you need to carry it
up or down the stairs it should be done by two people.
Be especially careful when you ride uphill or downhill.
Lift the front wheels while riding over thresholds or curbs.
The stroller should be lifted only by holding the immoveable elements of the frame.
The stroller must be pushed only by holding the elements designed for this purpose
(handles).
Do not hang additional weights (e.g. bags) on the handles or other parts of the
stroller as it may cause a change in the center of gravity, hence tipping the
wheelchair.
Do not load the stroller with more than a sixty-kilogram user and the load of 1 kg –
the weight of a bag under the seat.
Do not leave the wheelchair near the sources of fire or exposed to the sunlight for too
long as it can cause an increase in temperature of the upholstery and thus can lead to
the burns of the child.
During transportation (e.g. in a boot), the stroller must not be covered with heavy
goods because they may deform the structure of the stroller.
After each adjustment process all screws must be carefully checked so they are
tightened and all the parts are well fitted.
During the adjustment, disassembly of the stroller or its transportation the users
should be particularly careful so as to prevent pinched fingers.
ASSEMBLY OF THE STROLLER:
1. Release the safety strap on the side of the frame.
2. Pull the handlebar, and then press the lever back until it is unfolded.
3. Lower the bracket located at the back of the backrest.
4. Lock the brake.
5. Fasten the side parts of the upholstery.
6. Install the railing. Slide the side parts of the railing into the guides, then fasten the belt, on
which a wedge is located.
7. Install the footrest. Slide the footrest platform onto the tubes projecting from the front until
you hear a characteristic sound of locking.
Make sure to check that the footrest is locked.
8. Install the booth. Slide fasteners into the guides.
9. If necessary, install the cup holder.
Never insert the handle of the cup with a hot drink. This may cause burns to the
user or the child.
DISASSEMBLY OF THE STROLLER
1. Remove the cup holder.
2. Remove the railing. Release the belt located on the railing, and then press simultaneously
the red buttons on the sides of the railing and slide it off the guides.
3. Remove the booth. While holding red buttons located on the side parts of the booth, slide it
off the guides.
4. Remove the footrest. Press the buttons located on each side of the stroller by the footrest,
pull the footrest.
5. Release the brake.
6. Raise the bracket at the back of the backrest.
7. Detach the side parts of the upholstery and move it to the backrest.
8. Put the stroller on the surface (upside down) and press down.
9. Fasten the safety belt located on the side of the frame.
FOOTREST ANGLE ADJUSTMENT
Press simultaneously the buttons located in the upper part of the frame of the footrest.
Set the desired angle and release the buttons.
Be sure to check that the buttons are blocked.
FOOTREST LENGTH ADJUSTMENT
Unscrew and remove the screws on the tube of the footrest.
Set the desired length with the use of the holes on the tube.
Insert the screws into the holes and tighten them.
Note that on each side the screws should be in the holes on the same length.
Be sure to check that the screws are properly tightened.
BACKREST ANGLE ADJUSTMENT
Pull the cord located in the bottom edge of the backrest.
Holding it set the desired angle, then release it.
Be sure to check the backrest is blocked and whether each side is blocked in the
same position.
BACKREST LENGTH ADJUSTMENT
Remove the screws at the top of the backrest frame on the right and on the left.
Eject them, and then set the desired height.
Insert the screws and tighten them.
Be sure to check that the screws are tightened and are at the same height.
SEAT DEPTH ADJUSTMENT
Remove the screws located in the front part of the seat frame.
Eject them, and then set the desired depth.
Insert the screws and tighten them.
Be sure to check that the screws are tightened and are in the same position.
HEADREST
The stroller is equipped with a headrest that can be placed in two different positions.
STABILIZING BELTS
The stroller is equipped with stabilizing belts that can be placed in two different positions,
and their length can be adjusted.
Remember that a child using the stroller should be fastened with the properly
adjusted belts.
Optionally, the stroller can be equipped with protection belts.
BRAKE
In order to lock the brake press the centre of the rear crossbar. If you want to release it just lift
the center of the crossbar.
BOOTH
Assembly and disassembly of the booth is done by sliding in or sliding out the fasteners from
the guides.
In order to open the booth pull the front edge. If you want to close it push its front edge to the
back of the booth.
A "window" is mounted in the roof, in order to open it or to close it, unfasten or fasten the
velcro.
MAINTENANCE AND CARE
All elements of the frame and parts made of plastic should be cleaned with a damp cloth,
mild detergent can also be used.
The upholstery should be cleaned with a damp cloth or sponge with the use of mild detergent.
In the case of stubborn dirt, it should be washed in a washing machine at 400 C.
Do not leave the stroller in damp areas or do not expose it to rain, it may have an impact on
changing its parameters and aesthetics.
Before each use the stroller should be checked for the efficiency and operation of the brake.
At least once a week check the tire pressure.
At least once a month check the quality of the screwed connections, the state of wheels, tires
and bearings.
In case of any damage, please contact the manufacturer's service. It is
unacceptable to use the stroller in which a defect was found.
The stroller is available with pumped or solid rubber wheels. Pumped tires should be inflated
to 250 kPa.
After the end of its useful life the stroller is suitable for recycling.
The useful life of the stroller is 3 years from the date of manufacture.
BATCH NUMBER: given on the article.
Seat width: 40 cm
Seat depth: 35 - 40 cm
Back height: 68 - 73 cm
Stroller’s height: 114 cm
Overall dimensions when folded 106/47/43 cm
Maximum weight of the child: 60 kg
Fabrics used in the production of the stroller are certified by OEKO-TEX.
Oeko-Tex® Standard 100 confirms that the requirements contained in Annex
XVII of REACH (including the use of azo-dyes, nickel, etc.), US requirements
for total content of lead in children's articles ICPSIA, with the exception of
accessories made from glass)
and Polish legislation concerning the safety of textile products (Council of
Ministers of 6 April 2004. Journal of Laws No. 81, item. 743 as amended). It facilitates the
sale of textiles, mainly on the markets of European Union countries, Russia, Ukraine, Belarus,
USA, Canada, Japan and others.
GLOBAL REH sp. j.
ul. Piwna 17
98-220 Zduńska Wola, POLAND
VAT EU: PL 829 173 84 75
REGON: 360635870
e-mail: info@globalreh.com
KRS 0000539545 SĄD REJONOWY DLA ŁODZI-ŚRÓDMIEŚCIA W ŁODZI, XX WYDZIAŁ KRAJOWEGO
REJESTRU SĄDOWEGO
-
1
-
2
-
3
-
4
-
5
-
6
-
7
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI
Other documents
-
Meyra Sweety User manual
-
Vita Care DRVG0J User manual
-
Invacare Solara 3G User manual
-
-
-
-
Chicco PACK URBAN PLUS Owner's manual
-
Zooper SL398 User manual
-
Chicco Urban LE Stroller User manual
-
