F-15-582
June,1999
WATER KIT
P/N 37801
for 4HD Dual Wire Feeder
INSTALLATION
TO PREVENT ACCIDENTAL ELECTRIC SHOCK, BE SURE CONTROL CABLE IS DISCONNECTED
FROM POWER SOURCE OR INTERFACE BOX BEFORE WORKING INSIDE THE WIRE FEEDER.
1. Make sure the Control Cable is removed from the Power Source or Interface Box.
2. Remove Wire spools and Torch assemblies to prevent any damage.
3. Lay Feeder down on its side.
4. Depending on which side you want the kit to operate on, remove hole plugs and assemble the Bulkhead Adaptor
and Hose Assembly to the front and rear of feeder base using the screws supplied.
5. Return Feeder to the upright position and reconnect the control cable, torch and wire spools.
Options & Accessories
Water Kit for Mig 4HD Dual - Kit consist of inlet/outlet fittings,
mounting hardware, 12 ft. (2.4 m) water hoses with “B” size water
fittings and 2 quick disconnect fittings.
Optional Water Fittings and Connectors - The following items
can be used to connect the MT-350W, 450W and 650W to any
water circulator having 5/8” “B” size connectors:
Quick Disconnect Fittings - Two required - one fitting for each
circulator water hose to torch water hose connection or connect
torch directly to the water circulator ............................. 23610853
Water Hose Coupling - One required for each quick disconnect
fitting to water hose connection ......................................... 11N18
Water Hoses - Two required - one for water supply to the torch and
one for return to the water circulator. Use hose coupling (11N18) for
connecting water hoses together.
Shown with 2
kits installed
Water Hose (3 ft.) 20634
Water Hose (6 ft.) 20633
Water Hose (12 ft.) 40V76
Water Hose (25 ft.) 406196
Water Coupler
11N18
Gun Water Connection
included with torch
Quick Disconnect
Fitting
23610853