Page is loading ...
ABB Automation products | 2
ABB Automation products | 3
Status LED Display
CPU Operation and onboard I/O status
Run / Stop Switch
Control CPU operation
Ethernet CPU (In selected models)
With RJ45 Port
COM1
Online access, Modbus RTU master/slave, CS31-Bus
master, ACSII
Integrated onboard I/O
Convenient cost effective solution
ABB Automation products | 4
ABB Automation products | 5
Click on
“Documentation
”
Opens new
window
Choose“AC500+
CoDeSys”
ABB Automation products | 6
Select “Index”
Type “PM564-T-ETH”
and press ENTER
Select “open”
ABB Automation products | 7
Workspace
Tool Bar
Message
Window
Menu Bar
Object
Organizer
ABB Automation products | 8
ABB Automation products | 9
ABB Automation products | 10
ABB Automation products | 11
ABB Automation products | 12
By default
ABB Automation products | 13
If Internet access is existing CBP shows
by default ABB homepage
ABB Automation products | 14
3
2
1
Choose the
type of CPU
Select “OK” to start.
1
To create IO variable for the CPU, go
to expand OBIO and then double click
on the IO (Onboard IOs) selection
The IO tab will be open on your right
window with 2 child tabs. The 1
st
tab is
IO configuration, Click on the 2
nd
tab for
IO Mapping
2
Select where do you
want to store the
project
ABB Automation products | 15
Double click on the cell and give the name
of the IOs as shown.
Double click on the cell and give the name
of the IOs as shown.
Click on I/O mapping tab
Click to expand.
Click to expand.
ABB Automation products | 16
ABB Automation products | 17
ABB Automation products | 18
2. Click on the BOX icon
1. Click this field
ABB Automation products | 19
Select “???”, and press
F2, the Input assistant
window below will appear
ABB Automation products | 20
Right click here and
select “Assign”
/