EN-8
EN
Coffeemaker
SCE 3050SS / SCE 3051RD
Revision 05/2016
Copyright © 2016, Fast ČR, a.s.
OPERATING THE COFFEEMAKER
1. Open the lid A1 and fill the water tank A3 with the required amount of water. The water level
must at least cover the mark showing two water cups and must not go over the maximum mark
showing 10 water cups (i.e. 1.25 l).
Attention:
Only fill the water tank with cold drinking water. Do not use hot water.
The water tank has a maximum capacity of 1.25 litres of water.
The amount of brewed coffee will always be less than the amount of water you poured into
the water tank A3. During the coffee brewing process, approximately 10 % of the water is
absorbed by the ground coffee.
2. Place the permanent filter A7 or a disposable paper filter size no. 4 into the filter holder A8.
3. Pour ground coffee into the filter. Recommended dosage: 7 g of ground coffee per cup. Set the hot
water arm A2 so that it points above the filter.
Note:
If you wish to brew tea, pour the required amount of tea into the filter.
4. Shut the lid A1 and make sure that it is properly closed.
5. Place the glass kettle with the lid Aqs on to the hotplate Aqd and start the coffeemaker by setting
switch Aqf to position I (On). The red indicator light will be lit.
6. Once the entire batch of coffee has finished brewing, wait approximately 1 minute for the drip
process to complete fully. Now the coffee can be served.
7. If you wish to serve the coffee later, leave the kettle Aqs on the hotplate Aqd. The hotplate Aqd will
keep the coffee at an optimal serving temperature. The coffeemaker will automatically turn itself
off after 40 minutes of operation.
8. Once you empty the kettle, return it back on to the hotplate Aqd and turn off the coffeemaker by
setting switch Aqf to position 0 (Off). The red indicator light will turn off.
9. Allow the coffeemaker to cool down for at least 10 minutes before using it again.
Warning:
If you do not allow the coffeemaker to cool down, the water could overheat and result in
subsequent scalding by the escaping steam.
10. Before using the coffeemaker again, remove the coffee grounds and wash the permanent filter
A7 or remove the paper filter together with the coffee grounds and dispose of it together with
normal household waste. Rinse the filter holder A8 and the kettle Aqs with clean water. Dry it and
put it back in its place.
11. When not using the coffeemaker, turn it off and disconnect it from the power socket.
DRIP-STOP FUNCTION
• The Drip-Stop function will allow you to serve coffee before the end of the drip process.
1. Once at least half the amount of coffee is brewed, you may remove the kettle Aqs from the
coffeemaker. The Drip-Stop shut-off valve will be activated and coffee will stop dripping.
2. Serve the required amount of coffee and place the kettle Aqs back on the hotplate Aqd within
approximately 1 minute of taking it off to avoid the filter from overfilling with hot water.
3. When the kettle Aqd is placed back under the brew chamber A9, the drip process will resume
automatically.