Toro Spring Kit, for 79301 Vacuum Bagger Installation guide

Type
Installation guide
1
FORM NO. 3319–296
PART NO. 94–1592
INSTALLATION
INSTRUCTIONS
 
   
Loose Parts
Note: Use the chart below to identify parts used for assembly.
DESCRIPTION QTY. USE
Spring
Chain
Carriage bolt 5/16–18 x 1-1/4” (32 mm)
Washer 5/16” (19 mm)
1
1
1
3
Install between footrest and mower
Attach Chain to Tractor
1. Shut off engine and and wait for all moving parts
to stop. Remove spark plug wire(s).
POTENTIAL HAZARD
If you leave the wire on the spark plug,
someone could start the engine.
WHAT CAN HAPPEN
Accidental starting of engine could
seriously injure you or other bystanders.
HOW TO AVOID THE HAZARD
Pull wire off spark plug before you do any
maintenance. Also push wire aside so it
does not accidentally contact spark plug.
Installation
2
2. Remove existing hardware and clip from outer
right rear footrest support rod (Fig. 1).
3. Replace existing carriage bolt with longer
5/16 x 1-1/4” (32 mm) carriage bolt from kit
(Fig. 1).
4. Place retaining clip and two 5/16” (19 mm)
washers onto carriage bolt, then mounting link
of chain. Secure with third washer and existing
nut (Fig. 1).
5. Hook spring around wheel shaft at rear of mower
(Fig. 1).
m–3109
1
2
4
5
6
7
3
Figure 1
1. Carriage bolt 5/16–18 x
1-1/4” (32 mm)
2. Retaining clip
3. Mounting Link
4. Washer 5/16” (19 mm)
5. Chain
6. Nut (reuse existing)
7. Spring
Adjusting Height-of-Cut
When mower height-of-cut is changed, the spring
location in the chain links must also be changed.
1. Select spring attachment link according to chart
for the height-of-cut used.
2. Hook spring into recommended link (Fig. 2).
3
1
2
m–3183
Figure 2
1. Mounting Link
2. Link 1
3. Spring Hook
Height-of-Cut
Recommended
Link Position
1–2 in. (25–51 mm)
2–3 in. (51–76 mm)
3–4 in. (76–101 mm)
5
4
3–4
  • Page 1 1
  • Page 2 2

Toro Spring Kit, for 79301 Vacuum Bagger Installation guide

Type
Installation guide

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI