Toro Adapter Kit, 2001 and Earlier 42" Snowthrower to 2002 and Later GT Classic Garden Tractors Installation guide

Toro
Brand
Toro
Model
Adapter Kit, 2001 and Earlier 42" Snowthrower to 2002 and Later GT Classic Garden Tractors
Type
Installation guide
1
All Rights Reserved
Printed in the USA
2001 by The Toro Company
8111 Lyndale Avenue South
Bloomington, MN 55420-1196
Adapter Kit
2001 and Earlier 42 Snowthrower to a 2002 and Later GT
Classic Garden Tractor
Part No. 105–1503
Form No. 3327–143
Installation Instructions
Loose Parts
Note: Use the chart below to identify parts for assembly.
DESCRIPTION QTY. USE
Crank Support 1 Replacing the Crank Support
Pulley
Screw
1
1
Replacing the Pulley
Important These instructions are to be used when
installing your snowthrower. Refer to your operator
manual for complete snowthrower installation.
Replacing the Crank Support
Note: The first step only needs to be done if crank support
is already installed.
1. Remove hairpin cotter at U-joint and slide crank
handle out of support (Fig. 1).
m–5715
4
2
1
3
Figure 1
1. Crank handle
2. Crank support
3. U-joint
4. Hairpin cotter–small
2. Install the crank handle into the new crank support.
Install crank handle into the U–joint with hairpin
cotter (Fig. 1).
Replacing the Pulley
Note: The first three steps only need to be done if the
pulley is already installed.
1. Remove the belt off the snowthrower pulley (Fig. 2).
m–2788
1
2
3
4
Figure 2
1. Power take off (PTO)
pulley
2. Idler pulley
3. Belt guide
4. Snowthrower pulley
2. Remove the two screws from the pulley (Fig. 3).
3. Remove the pulley from the shaft (Fig. 3).
4. Install the new pulley onto the shaft. Make sure the
key is in place on the shaft (Fig. 3).
5. Install the two screws into the pulley (Fig. 3).
2
Note: Make sure that one of the screws is installed on top
of the key.
m–5714
2
3
1
4
Figure 3
1. Pulley
2. Screw
3. Key
4. Drive shaft
  • Page 1 1
  • Page 2 2

Toro Adapter Kit, 2001 and Earlier 42" Snowthrower to 2002 and Later GT Classic Garden Tractors Installation guide

Toro
Brand
Toro
Model
Adapter Kit, 2001 and Earlier 42" Snowthrower to 2002 and Later GT Classic Garden Tractors
Type
Installation guide
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents