FCC COMPLIANCE
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses and can
radiate radio frequency energy and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. However, there is no guarantee that interference
will not occur in a particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
• Consult the dealer or an experienced radio/TV technician for help.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause undesired operation.
Caution: Modifications not authorized by the manufacturer may void users authority to operate this
device.
CAN ICES-3 (B)/NMB-3(B).
LiPo BATTERY SAFETY INFORMATION
• Never leave the battery unattended while charging and charge in an isolated area.
• Keep away from ammable materials.
• Do not drop or subject to strong impact.
• Do not immerse the battery in water, and keep the battery in a cool, dry place.
• Only charge the battery with the specied included USB cable and do not over-charge.
• Only use the battery included in the device.
• There is a risk of the battery exploding, overheating or igniting. Do not disassemble, modify, heat or
short circuit the battery. Do not place it in fire or leave it in extreme heat.
• In the unlikely event of leakage or explosion, use sand or a chemical re extinguisher for the battery.
• Battery must be recycled or disposed of properly.
NOTE: Under the environment with electrostatic discharge, the toy may malfunction and require the
user to reset the toy. To reset the product, turn it off completely, then turn it back on. To ensure normal
performance, recharge the battery, as low battery may not allow full function.
PRODUCT BATTERY REMOVAL INSTRUCTIONS:
Internal battery is factory installed. Product disassembly and battery removal must be performed by an
adult. Open the product. When battery is completely visible, use scissors to cut a single battery wire.
Immediately wrap the cut wire end with tape to isolate it. Repeat until all battery wires are cut and
isolated and the battery is free from the rest of the product. Dispose of the battery in accordance with
your local battery recycling or disposal laws. NOTE: Opening of the product and/or removal or the
battery will render the product inoperative and voids manufacturer warranties. Dispose of the
remaining product components in accordance with local laws.
The handle from Georgie’s crate can be removed and turned into a sweet dog collar!
1. Ask an adult to cut both sides of the handle.
2. Write your name on the back of Georgie’s name tag.
3. Slide the collar through the loop on the name tag.
4. Wrap the collar around Georgie’s neck and tape it together.