Ideal 30-496 User manual

Ideal
Brand
Ideal
Model
30-496
Category
Cable assembly tools
Type
User manual

This manual is also suitable for

30-496 IDEAL TeleMaster™ Instructions
1) Use the cutting blade to remove old
connector if necessary. Start with a
clean, straight cut on the end of the
cable.
2) Use the round stripping hole to remove 2”
of jacket. Rotate the tool around the cable
to score the outer cable jacket. Bend cable
gently at the score mark to remove the 2”
jacket slug. Avoid cuttting too deep into the
cable or the twisted pairs may get nicked.
3) Arrange wires into proper order for your
application requirements
4) Trim wires to 1/2” of exposed length
using the cutter
5) Insert wires into modular plug and crimp in the appropriate
cavity of the tool. Squeeze handles closed and remove cable
assembly.
Optional (but highly recommended): test your cable assembly
with an IDEAL wiremap tester. VDV or LinkMaster™
30-496 TeleMaster
4
3
Finished cable assembly:
A)Conductors inserted to end of connector
B)Cable jacket past primary crimp area
A
B
1
CUTTER
2
STRIPPER
5
RJ-45 CRIMPER
RJ-11 CRIMPER
2 inches
1/2 inch
Pair 2
Pair 4
Pair 3Pair 1
T1
R2
T3
R4
T5
R6
T7
R8
Pair 2
Pair 4
Pair 3
Pair 1
T1
R2
T3
R4
T5
R6
T7
R8
568A
568B
Insert into connector with tab side down
IDEAL INDUSTRIES, INC
Becker Place, Sycamore, IL 60178 USA
815-895-5181 • 800-435-0705 in USA
www.idealindustries.com 7/12
©2012 IDEAL INDUSTRIES, INC
Tab
  • Page 1 1

Ideal 30-496 User manual

Ideal
Brand
Ideal
Model
30-496
Category
Cable assembly tools
Type
User manual
This manual is also suitable for
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents