Stinger SEADP2RED Owner's manual

Stinger
Brand
Stinger
Model
SEADP2RED
Type
Owner's manual

This manual is also suitable for

SEADP
Marine Drain Plug Light
IPX68 - 9 X LED
IMPORTANT NOTES!
Lights are for underwater use only.
Do not operate above water for over 5 minutes.
12V / DC operation only.
Supplied fuse must be used on Positive lead.
1. Remove existing drain plug.
2. Feed the SEADP power wire through the drain opening
and screw in the light assembly. Hand tighten rmly.
3. On the inside of the boat, leave enough slack in the
power cable so the drain plug can be removed. Secure
and route power cable to switch.
4. You can add a new dedicated switch or use an exist-
ing light switch that outputs 12V+ when ON. A 12V relay is
recommended.
SEADP SPECIFICATIONS
Housing Material Bronze
Light Source LED x 9
LED Power 9W
Beam Angle 120°
Working Temperature
-4° - 104° (F)
-20° - 40° (C)
IP Rating IP68
Certication
CE, RoHS
ATC(ATE20081436)
Dimensions
0.9 x 0.9 x 2.12in
23 x 23 x 54mm
Weight 4.52oz / 128g
LIMITED WARRANTY:
Stinger warrants this product to be free of defects in materials and
workmanship for a period of one (1) years from the original date of
purchase. This warranty is not transferable and applies only to the
original purchaser from an authorized Stinger dealer in the United
States of America only. Should service be necessary under this war-
ranty for any reason due to manufacturing defect or malfunction,
Stinger will (at its discretion), repair or replace
the defective product with new or remanufactured product at no
charge. Damage caused by the following is not covered under
warranty: accident, misuse, abuse, product modication or
neglect, failure to follow installation instructions, unauthorized
repair attempts, misrepresentations by the seller. This warranty
does not cover incidental or consequential damages and does
not cover the cost of removing or reinstalling the unit(s). Cosmetic
damage due to accident or normal wear and tear is not covered
under warranty.
INTERNATIONAL WARRANTIES:
Products purchased outside the United States of America are
covered only by that country’s Authorized Stinger reseller and not
by Stinger. Consumers needing service or warranty information for
these products must contact that country’s reseller for information.
Stinger is a Power Brand of AAMP Global
15500 Lightwave, Clearwater, Florida 33760
P: 888-228-5560
[email protected]
www.stingerelectronics.com
© 2019 Stinger
INSTALLATION
86
85
30
87
87a
SWITCH
12V+
Positive +
Negative -
ON
  • Page 1 1

Stinger SEADP2RED Owner's manual

Stinger
Brand
Stinger
Model
SEADP2RED
Type
Owner's manual
This manual is also suitable for
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents