Frigidaire B4VM-E Installation guide

B4VM-E
Frigidaire
Brand
Frigidaire
Model
B4VM-E
Type
Installation guide

This manual is also suitable for

Horizontal Drain Pan Strain Relief Kit
The Horizontal Drain Pan Strain Relief Kit consists of 2 brackets – the horizontal drain pan bracket and the vertical
drain pan support bracket – and 2 screws.
The first bracket, the horizontal drain pan bracket, is a 1” by 1” angle bracket that is 19” long. This bracket fits into
the horizontal drain pan under the coil support rod. To install this bracket, it is easiest to insert the bracket into the
air handler in the orientation shown and then while holding the coil up slightly, rotate the bracket underneath the
coil support rod.
The horizontal drain pan bracket should fit into the corner formed by the drain pan base and the raised center portion
and hold the coil support rod at the bracket bend location.
The second bracket in the kit, the vertical drain pan support bracket, is a 3” by 14” long bracket with a ½” flange. This
bracket should be inserted into the air handler between the side wall insulation and the existing side bracket with the
shorter ¼” coil capture flange. The bracket needs to be fit in between the screws that attach the filter rack. When
inserted properly, the ½” flange of the bracket should rest directly on top of the ¼” flange of the existing bracket and
capture the coil drain pan to hold it vertically.
Figure 1.
Figure 3.
Figure 2.
Figure 4.
INSTALLATION INSTRUCTIONS
INSTALLER: PLEASE LEAVE THESE INSTALLATION
INSTRUCTIONS WITH THE HOMEOWNER.
Holes should be drilled into the air handler cabinet side 1.5” from the bottom. The first hole should be 5” from the
front of the cabinet, the second hole should be 16” from the front of the cabinet (or 11” back from the first hole). The
holes should be 1/8” diameter and should go through the new bracket. Take care to not pierce the drain pan.
Insert the screws provided to attach the vertical drain pan
support bracket – this bracket will help keep the coil from
putting as much pressure on the horizontal drain pan.
11.000
5.000
1.500
.125
Figure 5.
7090870
Specifications & illustrations subject to change without notice or incurring obligations (07/15).
O’Fallon, MO, © Nortek Global HVAC LLC 2015. All Rights Reserved.
  • Page 1 1
  • Page 2 2

Frigidaire B4VM-E Installation guide

B4VM-E
Frigidaire
Brand
Frigidaire
Model
B4VM-E
Type
Installation guide
This manual is also suitable for
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents