3
ASSEMBLY
ASSEMBLY INSTRUCTIONS
Note: The bag (for mounting on the push handle) is not shown on the picture.
Please, make sure if these parts are in the package. Some of the parts may be pre-installed by the
manufacturer.
1. ASSEMBLY OF THE FRONT WHEEL FENDER TO THE FORK (a) AND THE FORK TO THE
FRAME (b).
2. ASSEMBLY OF THE HANDLEBAR
2-1 – Place the handlebar to the tube of the fork.
2-2 – Fix the handlebar with screw and nut
3. ASSEMBLY OF FRONT WHEEL
3-1 - Place the front wheel to the tubes of the fork.
3-2 – Fix with the screw.
4. ASSEMBLY OF THE PARKING DEVICE (on the rear tubes of the frame)
Note: When mounting, the parking device pedal must be up.
5. ASSEMBLY OF THE REAR WHEELS
5-1 – Mount the rear axle to the rear wheel
5-2 – Mount the rear wheel to the frame.
Note: Press the disassemble button to make it easier the rear axle to pass through the opening. Re-
lease the button to lock the wheel.
6. ASSEMBLY OF FENDERS OF THE REAR WHEELS
7. ASSEMBLY OF THE SEAT
Placetheseattotheframeandxwiththescrews.
8. DRESSING THE FABRIC ON THE SEAT
9. ASSEMBLY OF THE SAFETY BUMPER
9-1 – Align the connecting parts of the safety bumper to the protruding parts on either side of the seat
andpressuntilthebumpersisxed.
9-2 – Place the fabric on one of the arms and close the bumper.
10. ASSEMBLY OF THE CANOPY
10-1 – Press the buttons and insert both ends of the canopy to the connecting parts of the safety bumper.
CAUTION! The pins must be shown through the openings of the safety bumper.
10-2 – Unfold the canopy.
11. ASSEMBLY OF THE PUSH BAR
11-1 – Remove the stopper;
11-2 – Press the button and insert the tube of the handle, until you hear sound „click” and the button is
shown through the opening of the tube;
11-3 – Fix the handle by moving the red lever upwards.
12. ASSEMBLY OF THE STORAGE BASKET
Secure the storage basket with screws to the bar from the frame.
13. ASSEMBLY THE BAG TO THE PUSH BAR
14. ASSEMBLY OF THE UPPER FOOTREST
Insert both parts of the upper footrest in the openings of the seat.
To remove the upper footrest, press the button under each part of the footrest and pull it out.
15. ASSEMBLY OF THE BELL
Secure the bell with a screw.
16. ASSEMBLED TRICYCLE
IMPORTANT! Follow exactly the instructions given and check the pictures.
IMPORTANT! After each operation, make sure that you have followed the instructions correctly and
thexingisstable!
CAUTION! The screws must be well tightened so they will not become loose. If they are loose, this
may lead to dismantling of the tricycle and injury for the child