1x THAR-FORD4 T-Harness
1x THAR-FORD1 T-Harness
Wiring Connections
The Vehicle Remote Starter needs to be connected to various components of the vehicle for proper operation.
The user manual provides detailed instructions on how to make the necessary wiring connections.
Important Safety Information
The installation of safety elements is mandatory for the proper functioning of the Vehicle Remote Starter. The
hood pin switch is an essential security element and must be installed. Incorrect connections can cause
permanent damage to the vehicle, so it is crucial to have the device installed by a qualified technician.
Product Usage Instructions
1. Ensure that all required parts, including the 7.5 Amp. fuse, 1 Amp. Diode, THAR-FORD4 T-Harness, and
THAR-FORD1 T-Harness, are available.
2. Refer to the wiring diagram provided in the user manual to identify the appropriate connections for the Vehicle
Remote Starter.
3. Follow the wiring instructions carefully to connect the Vehicle Remote Starter to the ignition barrel, driver door
pin, parking lights, OBD-II connector, and other relevant components.
4. Pay special attention to the connection of the hood pin switch. It is mandatory to install the hood pin switch for
proper operation.
5. Ensure that all connections are secure and properly insulated to prevent any electrical issues.
6. If the parking lights require more than 10 Amp., connect the remote starter’s power directly to the vehicle’s
battery with the appropriate fuse.
7. If necessary, connect the remote starter’s fused 12V power wire directly to the T-Harness if it cannot be
powered through Data-Link.
8. After completing all the wiring connections, test the Vehicle Remote Starter to ensure it functions as intended.
Note: These usage instructions provide a general overview. For detailed step-by-step instructions, please refer to
the user manual provided with the product.
Vehicle functions supported in this diagram
FIRMWARE VERSION VERSION LOGICIELLE
