15PC NO-SPILL AUTOMOTIVE COOLANT FILLING
SET
MODEL NO: VS0045
Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these instructions,
and properly maintained, give you years of trouble free performance.
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE
THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR
PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
1. SAFETY
WARNING! Ensure all Health & Safety, local authority, and general workshop practice regulations are strictly adhered to when
using product.
WARNING! Ensure the engine and cooling system have cooled down, before opening the radiator cap.
9 Maintain tools in good and clean condition for best and safest performance. DO NOT use funnel kit if damaged.
9 Wear suitable clothing to avoid snagging. DO NOT wear jewellery and tie back long hair.
9 Wear approved eye protection. A full range of personal safety equipment is available from your Sealey stockist.
9 Operate in a well ventilated area and avoid breathing in exhaust fumes.
9 Keep yourself, tools, and test equipment away from hot engine parts.
8 DO NOT use this tool for any purpose other than that for which it is designed.
9 Never lay tools on the vehicle’s battery. This may short the terminals together, causing harm to yourself, the tools, or the battery.
9 Account for all tools and parts being used and do not leave any in the engine bay.
9 Keep children and other unauthorised persons away from the working area.
9 Keep test kit parts clean and keep this in a safe, dry, childproof location.
IMPORTANT: Always refer to the vehicle manufacturer’s service instructions, or a proprietary manual to establish the current procedure
and data. These instructions are provided as a guide only.
2. INTRODUCTIONi
Uniquedesignpreventsoverllingandairbubblesbyturningtherotaryswitch.Suitableformostvehicleswithaddedadaptorsfor
FordandGMvehicles.The5”extensionsaredesignedforhard-to-reachllingexpansionbottles.Contents-Funnelwithswitch,lid,
caps large, medium and small, threaded cap, GM adaptor, Ford adaptor, 5” extension x2 and 45° elbow x2.
3. SPECIFICATION
Model no: ......................................................... VS0045
Automotivecoolantllingset: ................... No spill 15pc
4. OPERATION
4.1. Install the appropriate adapter and cap to the radiator or coolant tank.
4.2. Press the funnel into the adapter. If an angled adapter and/or extension is needed, it must be installed prior to installing the funnel.
4.3. Slowly pour coolant into the funnel until the funnel is approximately a third full.
4.4. With the funnel attached, start the engine.
4.5. Add coolant until the cooling system is full.
4.6. Ifuidremainsinthefunnel,squeezeandholdthelargeradiatorhosewhilepressingdowntheuidstopperintotheclosedposition.
4.7. Removethefunnelandemptytheremaininguidintoanappropriatecontainer.
4.8. Remove adapters and reinstall the cooling system cap.
Original Language Version
© Jack Sealey Limited
Refer to
instruction
manual
Wear eye
protection
Wear
protective
gloves
Wear
protective
clothing
VS0045 Issue:1 07/03/23