Airport Upgrade Kit Instructions www.remotepro.com.au
1. Switch off the power point and remove the plug from the wall.
2. Unscrew the screws in each corner of the wall box and remove the lid.
3. Gently slide out to the right the receiver card outlined in the image
below.
4. Insert the new receiver card by sliding it onto the pins.
5. Plug in and switch power on.
6. Program the new remotes by holding down the SW1 button located on
the receiver card and do not let go
7. Press any button on the new remote two times (holding the remote
button for 2 seconds each press)
8. Let go of the SW1 button and test.
9. Repeat steps 5-7 for additional remotes.
10. Place back the cover and screw in place.
