Palm TREO 500 Disassembly Procedure

  • Hello! I am an AI chatbot trained to assist you with the Palm TREO 500 Disassembly Procedure. I’ve already reviewed the document and can help you find the information you need or explain it in simple terms. Just ask your questions, and providing more details will help me assist you more effectively!
Treo 500
DISASSEMBLY PROCEDURE
APR 30, 2007
IMPLEMENTS of ASSEMBLY /DISASSEMBLY
a clip
a screw driver
(T5)
a pick
BATTERY COVERBATTERY
ANTENNA COVER
Use the pick to pry antenna cover surround
INNER FRAME
Release the 4 screw at the corner
Use the pick to pry up inner frame from middle case.
MPCB (1)
Speaker Rubber
LCD FPC Connector
Keypad Connector
2M Camera Connector
MPCB (2)
Bend the middle case, then be
made the hook release.
Hold the battery connector to take
out MPCB from middle case.
KEYPAD FPCKEYPAD MODULE
Its easy to take out the Keypad FPC.
Bending the middle case while push
the behind keypad module.
Take out the Keypad Module.
QWERTY KEY
Its easy to take out
the Qwerty Key.
KEYPAD COVER
Use the pick to pry the hook
release from middle case.
The other side the same
QWERTY KEY
Its easy to take out
the Qwerty Key.
LCM COVER
The finger press the LCM
cover with force.
Then push the LCM cover to
the leader direction.
The LCM cover is separated
from middle case.
Take out the LCM cover.
LCD PANEL
Bend the middle case, while push the
panel in opposite direction.
Be made the hook release from panel.
Be careful dont remain the
fingerprints on the panel.
Take out the LCD panel.
Disassembly Finished
Treo 500
LCM COVER & LENS
DISASSEMBLY
APR 30,2007
BATTERY COVERBATTERY
ANTENNA COVER
Use the pick to pry antenna cover surround
SCREWS on the INNER FRAME
Release the 2 screw at the top inner frame
LCM COVER
The finger press the LCM
cover with force.
Then push the LCM cover to
the leader direction.
The LCM cover is separated
from middle case.
Take out the LCM cover.
END
/