Assembling
12
›
Charge with the PC data cable
Before charging, ensure that your PC is turned on.
Open the cover to the multifunction jack on the side
1
of the phone.
Plug one end (micro USB) of the PC data cable into the
2
multifunction jack.
Plug the other end of the PC data cable into a USB port
3
on a PC.
Depending on the type of PC data cable you are
using, it may take some time before charging
begins.
When the battery is fully charged (the battery icon is
4
no longer moving), unplug the PC data cable from the
phone and then from the PC.
When the battery is fully charged (the battery icon is
4
no longer moving), unplug the travel adapter from the
phone and then from the power outlet.
Do not remove the battery before removing the •
travel adapter. Doing this may cause damage to
the phone.
To ensure peak performance of your battery,
•
fully charge and discharge (use until empty) the
battery the rst two or three times.
When you charge the battery for the rst time, charging
your battery completely may take about 3 hours. Because
the battery is a consumable part, the battery will gradually
wear out and the charging time will be reduced. The initial
charging capacity of your battery is about 1000 mAh.