2. Biamp
  3. BPAK (Backpack Clip Kit)

Biamp BPAK (Backpack Clip Kit) Installation guide

  • Hello! I have reviewed the provided installation guide for the Desono BPAK, which details how to attach Tesira units like AMP-450BP, AMP-450P, TCM-X and TCM-XA to Desono C-IC6 and C-IC6LP back cans. It also explains the kit's contents and installation steps, plus, how to use the conduit cover for strain relief. I'm ready to answer any questions you have about this device.
  • What is the purpose of the Desono BPAK Backpack Kit?
    What components are included in the kit?
    What is the purpose of the cover provided with the kit?
A: 9300 Gemini Drive, Beaverton, OR 97008 W: biamp.com
Desono BPAK
Installation Guide
PRODUCT DESCRIPTION
The Desono BPAK Backpack Kit allows a Tesira AMP-450BP, AMP-450P,
TCM-X or TCM-XA to be attached to the top of a Desono C-IC6 or C-IC6LP
back can.
C-IC6 or C-IC6LP with Tesira unit
secured with backpack clips and
conduit cover
(shown with an AMP-450BP)
Tesira Unit
(AMP-450BP shown)
C-IC6
C-IC6LP
Kit Contents
Clips and M3 screws
(2 each)
Tesira CAT5 Jumper
cable (not shown)
Cover
A: 9300 Gemini Drive, Beaverton, OR 97008 W: biamp.com
INSTALLATION
3. A cover is provided for conduit usage or strain relief. Punch out the
cut-out, attach conduit î‚¿tting or cable clamp and feed wiring through
the opening. Connect wiring per the device instructions. Insert cover
tabs into the slots on the Tesira unit and secure the cover with the
thumbscrew.
1. Attach clips. Installation method is the same for C-IC6LP.
2. Fully slide unit into clips
M3 Flat Head Screw
Backpack Clip
Use this hole for seismic
wire attachment or to
further prevent movement
on the back can
585.0111 25MAY2023
/