2. JasonL
  3. STBP2187PT

JasonL STBP2187PT Operating instructions

  • Hello! I've reviewed the installation guide for the jason.l Switch System 2 Person Workstation. This document provides detailed instructions on how to assemble the 1800x700 mm workstation, including attaching the legs, beams, and table tops, emphasizing the importance of tightening all bolts before securing the tops. I'm ready to assist with any questions you have about its assembly or features.
  • What tools are needed for assembly?
    What should I do if there are pre-drilled holes in the table top?
    What is the important step before attaching the table tops?
Note: Please ignore any pre-drilled holes or nut inserts that maybe present in your top(s). They will not match your particular
table/desk base and woods screws will be required to be screwed directly into the underside of the top.
Note: It is important to fully tighten all bolts and screws before attaching the top(s) so that the frame is suciently rigid.
Failure to do this may aect stability once the tops are attached.
Tools Required: Power screwdriver.
INSTALLATION GUIDE
Switch System
2 Person Workstation
Size: 1800x700 mm
Page 1 of 4
Need help!
Call us on
1300 527 665
www.jasonl.com.au
Table Top x2 (1800x700mm)
Leg x4
Leg Bracket x4
Beam Bracket x8
Short Beam x2 (950mm)
Long Beam x2 (1325mm)
L-Bracket x10
1
2
3
4
5
6
7
Hex Nut x4
L-Bracket screws x10
Hex Head screws x16
M8x25mm Dome Head x4
8
9
10
11
COMPONENTS
SCREWS
Page 2 of 4
INSTALLATION GUIDE
Switch System
2 Person Workstation
Size: 1800x700 mm
Need help!
Call us on
1300 527 665
www.jasonl.com.au
6
4
3
7
9
11
2
1
5
8
Page 3 of 4
INSTALLATION GUIDE
Switch System
2 Person Workstation
Size: 1800x700 mm
Need help!
Call us on
1300 527 665
www.jasonl.com.au
Join 3 L-Bracket through each Long Beam
and 2 L-Bracket through each Short Beam.
Join Leg Brackets to each Leg using screws to secure them, as follow.
Securely connect each Beam to each Beam Bracket. Screw to secure. Insert Hex Nut on each Beam Bracket.
01
03 04
02
INSTALLATION GUIDE
Switch System
2 Person Workstation
Size: 1800x700 mm
Need help!
Call us on
1300 527 665
www.jasonl.com.au
Page 4 of 4
Once we get the whole frame ready, ensure the worksurface is
centered over the frame. If you are planning to install a divider
screen, leave a 25mm gap between tables.
25mm
06
Directly screw into table tops, using L-Bracket screws through each L-Bracket.
07
Note: If you are planning to install Pincer Brackets
like the image to the right, you need to attach these
brackets before continuing.
Position as presented, and proceed to screw to ensure each corner of the frame.
05
If this bolt does not drop into the joint
use the Allen key to screw it all the way
in so that it creates its own thread.
This will ensure a nice, tight joint.
Note: It is important to fully tighten all bolts and screws before
attaching the top(s) so that the frame is suciently rigid. Failure
to do this may aect stability once the tops are attached.
/