2. VISUAL COMFORT
  3. 8537401 Barn Light Outdoor Wall 1.0

VISUAL COMFORT 8537401 Barn Light Outdoor Wall 1.0 User manual

  • Hello! I've reviewed the Installation Instructions for the Visual Comfort & Co. Barn Light models 8537401, 8637401, 8737401, and 8837401. This document provides a step-by-step guide on how to install the light fixtures, including wiring instructions and information about using the correct junction boxes and dimmers. I'm ready to answer any questions you may have about this document or the installation process.
  • What type of junction box should be used?
    Is this fixture safe for wet locations?
    Can this fixture be dimmed?
Installation Instructions for
Barn Light Outdoor Wall
1.0
990W8_37401-BRL
8537401, 8637401, 8737401, 8837401
1
GP I :ENERAL RODUCT NFORMATION
These fixtures are intended to be installed utilizing compliant junctionNEC
boxes.
This product is safety listed for wet locations.
Incandescent version may be dimmed with a standard incandescent dimmer.
LED LEDversion may be dimmed with a dimmer. Consult lamp manufacturer
for additional information.
This instruction shows a typical installation.
CAUTION RISK OF FIRE-
This product requires installation by a qualified electrician.
Before installing be sure to read all instructions and
TURN THE POWERTO THE ELECTRICAL BOX OFF.
CAUTION RISK OF FIRE-
This product must be installed in accordance with the applicable
installation code by a person familiar with the construction and
operation of the product and the hazards involved.
Use minimum 90°c supply conductors.
SAVETHESE INSTRUCTIONS!
7400 Linder Ave, Skokie, IL 160077
800.969.3347
www.visualcomfort.com
©2023 Visual Comfort & Co.. All rights reserved. The Visual
Comfort & Co. logo is a registered trademark of Visual Comfort
& Co. Visual Comfort & Co. reserves the right to change
specifications for product improvements without notification
2
1A
Secure the mounting plate to the junction box.
Optional: Feed fixture wires through the arm extension and screw the threaded end of the fixture arm into the fixture.
Feed the fixture wires into the fixture base.
Insert the fixture arm into the fixture base and secure in place with the provided allen screws.
Connect the fixture to a suitable ground in accordance to local electrical codes.
Connect the white fixture wire to the neutral power line wire with a wire nut.
Connect the black fixture wire to the hot power line wire with a wire nut.
Neatly place the wires into the junction box, mount the fixture base onto the mounting plate studs, and secure it with the
two cap nuts.
Screw the lamp into socket. Refer to the label on the socket for Max Wattage Information.
Caulk around the base of the fixture with waterproof construction sealant.
1
2
3
4
5
Install the Fixture
6
7
10
LAMP
JUNCTION
BOX
NEUTRAL WIRE
HOT WIRE
WHITE
WIRE
BLACK
WIRE
MOUNTING
PLATE
FIXTURE
CAP NUT
ARM
EXTENSION
ALLEN
WRENCH
ALLEN SCREW
8
9
10
7
64
4
/