2. Lee Precision
  3. S23655 Carbide Factory Crimp Die

Lee Precision S23655 Carbide Factory Crimp Die Operating instructions

  • Hello, I have reviewed the instructions for the LEE PRECISION Crimp Die S23655. This document explains how to properly use the die to crimp bullets and achieve uniform start pressure. I'm ready to answer your questions about the product and its functionality.
  • How to adjust the crimp?
    How much pressure to apply when crimping?
    What to do when removing the die?
INSTRUCTIONS: Screw the factory crimp die in to touch the shell holder, plus � turn
more. It is best to start with too little crimp, as you can adjust in for more. Finger tighten
lock ring. This locks to both the die and the press and it will never move. When the four
splits in the collet are closed, maximum crimp has been achieved. Do not try for more,
as the die will be damaged, and the crimp excessive. Be certain to give the lever a firm
push at end of the stroke to close the collet and apply crimp (25 lbs. minimum).
S23655
WARNING: This product may contain steel alloyed with trace amounts
of lead and other elements which are known to the State of California
to cause reproductive harm and cancer. For more information, go
to www.P65Warnings.ca.gov. To prevent exposure, do not alter the
product by welding, grinding, etc.
FACTORY CRIMP DIE
FACTORY CRIMP DIE
4275 COUNTY ROAD U · HARTFORD WI 53027
www.leeprecision.com
FACTORY CRIMP DIE
Beer accuracy with factory crimped ammunition, a must for hunting ammunition.
Uniform start pressure produces uniform velocity.
Crimp bullets in place just like factory ammunition.
The Lee Factory Crimp™ Die does not seat the bullet, it should be seated with
your regular bullet seating die. Seat to the desired depth. If bullet has a crimp
groove, it is usually best to seat the bullet so most of the groove is inside
the case mouth. If the load data will not allow this seating depth, it is okay to
crimp below the crimp groove.
• Bullets do not need a crimp groove as the Lee Factory Crimp Die will form
one while crimping. However, it requires a harder push on the press lever
to form the crimp.
• When removing the die, always loosen by the lock ring. This insures the
lock ring will maintain its exact seing for future use.
• Trim length is not critical. However, be certain that your cases are no
longer than specications; as a case excessively long will pinch the bullet
in the end of your gun’s chamber and cause dangerous pressures. Cases
trimmed excessively short cannot be crimped.
LEE PRECISION, INC.
4275 COUNTY ROAD U · HARTFORD WI 53027
www.leeprecision.com
  is a trademark of Lee Precision
© PRINTED IN USA
/