2. Industrial & lab equipment
  3. Electrical equipment & supplies
  4. Electrical supplies
  5. Electrical wallplates
  6. SUR-RON
  7. Light Bee

SUR-RON Light Bee User manual

  • Hello! I have reviewed the user manual for the SUR-RON Light Bee electric off-road bike. The document provides instructions for adjusting the rear shock absorber, installing the number plate, and mounting the front tire. I am ready to answer any questions you may have regarding the procedures outlined within the instruction manual.
  • What tool should I use to tighten the axle if I have a reversed front shocker?
    What size inner hexwrench do I need for the 4MG bolts in the bottom of the absorber?
    What is the recommended torque for the 4MG bolts?
    What size hex wrench do I need for the front tire axle?
For shipping reasons, the anufacturer sets the rear shocker to
a default level, please adjust the rear absorber accord to your
weight and riding habit before use.
If the reversed front shocker (e.g. FASTACE) is chosen, please
use Wrench (# 19) to tighten the axle, use # 5 inner hexwrench
to tighten
the 4MG bolts in the bottom of the absorber.
The tighten torque is 8~10N.
Note
:
Rear Shocker Adjustment
1. Make the 4 black nylon tighten strips(200mm) go through
the 4 holes on the number plate as the picture shown.
2. Tighten the number plate on the front fork as the picture shown.
1. Using the Hex wrench( #8)
to get off the front tire axle.
2. Put the front tire into the
installation position of the front
fork (Please sure the
front
tire moun
ting will
be well matched with the
disc brake's clipper).
3. Insert the front tire axle,
and make sure the axle will
go through the front tire and
fork as the picture shown.
4. Use the Hexwrench
(#8) to tighten up the
front tire axle.
Number Plate
Installation
Front Tire
Installation
www.elecycles.com [email protected]
/