Hanover RETROTABLE Installation guide

  • Hello! I am an AI chatbot trained to assist you with the Hanover RETROTABLE Installation guide. I’ve already reviewed the document and can help you find the information you need or explain it in simple terms. Just ask your questions, and providing more details will help me assist you more effectively!
HanoverOutdoorFurniture
IMPORTANT
Ifyouhaveanyproblemswiththisproduct(missingordamagedparts,assemblyissues,etc.),
PLEASEDONOTRETURNTOTHERETAILER/STORE
fromwhereyoupurchasedtheproduct.
PleasecallourTollFreeCustomerServiceHotlineat:18004163511
Between9:00AMand5:00PMEasternTime,MondaythroughFriday
Orvisitourwebsiteat:www.hanoverproducts.com
Toexpediteanyfuturewarrantyclaims,pleaseretaintheInstructionSheet,Warranty
Cardandreceiptforfutureuse.
For additionalonlinesupportonassembly,troubleshootingandcare&maintenanceofyouroutdoor
furniture,pleasevisitourwebsiteat:www.hanoverproducts.com.
6/1/2015(a)
BPS03723
Step 1:
Step 2:
Fig. 1
Fig. 2
.
Identify all parts packed in the carton against the parts list. Remove all protective materials. If you are missing any parts or
are unsure as how to proceed with the assembly,
With the help of another person, place table top upside down on a non-abrasive surface to avoid scratching the top of the rim.
Identify the upper leg and lower leg. Insert the upper leg into lower leg as shown in .
s
sides
IMPORTANT NOTE: Damage to welds or frames resulting from over tightened bolts or improper assembly is not covered
under our warranty. Please read all instructions carefully before assembly. If you have any questions regarding your
assembly,
please call our Product Specialists immediately at 16 3511. Do
not attempt to assemble the chair if any parts are damaged or missing.
call our Product Specialists at 16 3511.
1-800-4 -
Attach table leg to table top using a bolt and washer as shown in . Guide bolt through hole in table leg, into pre-drilled
hole in the table top. Some adjustments may be necessary to ensure proper alignment of the table legs.
Repeat for other three . Your table is now ready for use.
Step 3:
Do not over tighten
1-800-4 -
PARTS LIST QTY
1
1
1
DESCRIPTION ORDER PART #
* NOTE: PARTS SHOWN ON PARTS LIST ARE NOT TO SCALE
FOOT CAP
FACTORY ASSEMBLY
4
4
HEX BOLT DRIVER
UPPER LEG
Ø6.5 X 1.0 MM
WASHER
TABLE TOP
LOWER LEG
1/4" X 42 MM BOLT
Fig. 1 Fig. 2
A
B
C
D
E
F
B
C
E
D
A
HW0004
1
HW0039
HW0006
SZ5450
FOOT CAP
IMPORTANT!! PLEASE READ ENTIRE INSTRUCTION SHEET BEFORE ASSEMBLY!!
TO EXPEDITE WARRANTY CLAIMS PLEASE KEEP INSTRUCTION SHEET, WARRANTY CARD AND COPY OF RECEIPT
/