Technicolor 7200.20 DOCCSIS 3 User manual

Hello! I am an AI chatbot trained to assist you with the Technicolor 7200.20 DOCCSIS 3 User manual. I’ve already reviewed the document and can help you find the information you need or explain it in simple terms. Just ask your questions, and providing more details will help me assist you more effectively!

How to set up Wireless on Technicolor 7200.20 DOCCSIS 3 Modem

1. Open a Browser and type http://192.168.0.1 in the address bar, leave the

user empty and type “admin” as the password then click OK

Note: You might have a problem when using IE, try using another browser.

2. Click Wireless > at Radio check following parameters:

2.1 Interface -> Enable or Disable Wireless

3. Primary Network for setting Wireless SSID Security, check following:

3.1 Network Name (SSID) > Wireless signal

3.2 How to set up Wireless parameters as shown

WEP

1. Primary Network select Disable WPA-PSK and WPA2-PSK

2. WEP Encryption > select Security WEP (64-bit) or WEP (128-bit)

3. Network Key > set the pass code to use Wireless

4. When finish click Apply to save setting

WPA-PSK, WPA2-PSK

1. For Primary Network, select Disable at WEP Encription

2. To use only WPA-PSK, select Disable at WPA2-PSK

3. To use only WPA2-PSK, select Disable at WPA-PSK

4. To use both WPA-PSK and WPA2-PSK, select Enable both. By Default

both parameters are Enable

5. WPA Pre-Shared Key > set the pass code to use Wireless

6. When finish click Apply to save setting

/