HQ Power VDPCRGB3 User manual

Page is loading ...

VDPCRGB3

2

A address selection A adresinstelling

B DMX input B DMX-ingang

C DMX output C DMX-uitgang

D power connecto

r

D voedingsaansluiting

E RJ45 output E RJ45-uitgang

F RJ45 input F RJ45-ingang

A adressage

B entrée DMX

C sortie DMX

D prise d’alimentation

E sortie RJ45

F ent

r

ée RJ45

A selección de la

dirección

B entrada DMX

C salida DMX

D entrada de

alimentación

E salida RJ45

F entrada RJ45-

A Einstellung der Adresse

B DMX-Eingang

C DMX-Ausgang

D Anschluss

Stromversorgung

E RJ45-Ausgang

F RJ45-Eingang

VDPCRGB3

3

USER MANUAL

1. Introduction

To all residents of the European Union

Important environmental information about this product

This symbol on the device or the package indicates that

disposal of the device after its lifecycle could harm the

environment. Do not dispose of the unit (or batteries) as

unsorted municipal waste; it should be taken to a

specialized company for recycling. This device should be

returned to your distributor or to a local recycling service. Respect the

local environmental rules.

If in doubt, contact your local waste disposal authorities.

Thank you for choosing the Velleman! Please read the manual

thoroughly before bringing this device into service. If the device was

damaged in transit, don't install or use it and contact your dealer.

2. Safety Instructions

Keep this device away from children and unauthorized

users.

Keep this device away from rain, moisture, splashing and

dripping liquids. Never put objects filled with liquid on top of

or near the device.

Be very careful during the installation: touching live wires

can cause life-threatening electroshocks.

• Damage caused by disregard of certain guidelines in this manual is

not covered by the warranty and the dealer will not accept

responsibility for any ensuing defects or problems.

• All modifications of the device are forbidden for safety reasons.

Damage caused by user modifications to the device is not covered

by the warranty

.

• A qualified technician should install and service this device.

• Do not switch the device on immediately after it has been exposed

to changes in temperature. Protect the device against damage by

leaving it switched off until it has reached room temperature.

• Make sure that the available voltage does not exceed the voltage

stated in the specifications of this manual.

VDPCRGB3

4

3. General Guidelines

Refer to the Velleman

®

Service and Quality Warranty on the last

pages of this manual.

• The VDPCRGB3 should only be used indoors.

• Protect this device from shocks and abuse. Avoid brute force when

operating the device.

• Protect the device against extreme heat and dust.

• Familiarise yourself with the functions of the device before actually

using it. Do not allow operation by unqualified people. Any damage

that may occur will most probably be due to unprofessional use of

the device.

• Only use the device for its intended purpose. Using the device in an

unauthorised way will void the warranty.

4. Features

• small intelligent 3 channel DMX controller for LED RGB strips

• DMX or auto program selection via DIP switches

• for use with: CHLR4RGB

5. Overview and use

Refer to the illustrations on page 2 of this manual.

• For wiring instructions, see table below. Do not plug the power

supply into the mains before all connections are made!

terminal connect to

DC- GND of power supply

DC+ positive pole of power supply

COM positive pole of LED-strip

CH1 LED-strip channel 1

CH2 LED-strip channel 2

CH3 LED-strip channel 3

Notes:

1. Do not use a 24VDC power supply to power 12VDC LED strips.

2. Never connect the COM terminal to ground! It is internally

connected to the DC+ terminal!

• When using a DMX system, set the DMX address

(see §6) and plug in the DMX-cable [B].

• Connect a DMX cable to the DMX-output [C] to

continue the DMX line or terminate the chain with

a 120Ω resistor between pin 2 and 3.

• Connect the power supply to the mains.

VDPCRGB3

5

6. DIP switch settings

• The controller can work in 2 modes:

o DMX mode

o internal program mode

DMX mode

• To enable DMX mode, switch 10 must be set in the OFF position.

• Switches 1 ~ 9 determine the DMX starting address. The address is

determined by the switches in the ON-position. E.g.:

Switches 1, 3 and 6 are ON. The address becomes:

switch value

1 001

3 004

6 032

total:

037

The DMX address for this example is 037.

Built-in programs

• To enable the internal program mode, switch 10 must be set in the

ON position.

• The other switches determine the current program.

switch position

program

1 ON red

2 ON green

3 ON blue

4 ON yellow

5 ON purple

6 ON cyan

7 ON white

8 ON changing colours (adjustable speed)

9 ON fading colours (adjustable speed)

• When in changing or fading colours mode, the changing or fading

speed is determined by switch 1~7.

o switch 1 ON: slowest speed

o switch 7 ON: fastest speed.

Note: When multiple speed switches are set, the highest setting will

be used.

VDPCRGB3

6

7. Maintenance

• All screws should be tightened and free of corrosion.

• The electric power supply cables must not show any damage. Have

a qualified technician maintain the device.

• Disconnect the device from the mains prior to maintenance

activities.

• Wipe the device regularly with a moist, lint-free cloth. Do not use

alcohol or solvents.

• There are no user-serviceable parts.

• Contact your dealer for spare parts if necessary.

8. Technical specifications

DMX channels 3 (red - green - blue)

power supply 12-24VDC (PSU not incl.)

power consumption < 1W

power output

12V < 216W

24V < 432W

output current 6A (each channel)

max. load 25m

dimensions 125 x 55 x 42mm

weight 0.12kg

Use this device with original accessories only. Velleman nv

cannot be held responsible in the event of damage or injury

resulted from (incorrect) use of this device. For more info

concerning this product, please visit our website

www.velleman.eu. The information in this manual is subject to

change without prior notice.

This manual is copyrighted. The copyright to this manual is

owned by Velleman nv. All worldwide rights reserved. No part of

this manual may be copied, reproduced, translated or reduced to any

electronic medium or otherwise without the prior written consent of

the copyright holder.

Page is loading ...

Velleman® Service and Quality Warranty

Velleman® has over 35 years of experience in

the electronics world and distributes its

products in more than 85 countries.

All our products fulfil strict quality

requirements and legal stipulations in the EU.

In order to ensure the quality, our products

regularly go through an extra quality check,

both by an internal quality department and by

specialized external organisations. If, all

precautionary measures notwithstanding,

problems should occur, please make appeal to

our warranty (see guarantee conditions).

General Warranty Conditions Concerning

Consumer Products (for EU):

• All consumer products are subject to a 24-

month warranty on production flaws and

defective material as from the original date of

purchase.

• Velleman® can decide to replace an article

with an equivalent article, or to refund the

retail value totally or partially when the

complaint is valid and a free repair or

replacement of the article is impossible, or if

the expenses are out of proportion.

You will be delivered a replacing article or a

refund at the value of 100% of the purchase

price in case of a flaw occurred in the first year

after the date of purchase and delivery, or a

replacing article at 50% of the purchase price

or a refund at the value of 50% of the retail

value in case of a flaw occurred in the second

year after the date of purchase and delivery.

• Not covered by warranty:

- all direct or indirect damage caused after

delivery to the article (e.g. by oxidation,

shocks, falls, dust, dirt, humidity...), and by

the article, as well as its contents (e.g. data

loss), compensation for loss of profits;

- frequently replaced consumable goods, parts

or accessories such as batteries, lamps, rubber

parts, drive belts... (unlimited list);

- flaws resulting from fire, water damage,

lightning, accident, natural disaster, etc. …;

- flaws caused deliberately, negligently or

resulting from improper handling, negligent

maintenance, abusive use or use contrary to

the manufacturer’s instructions;

- damage caused by a commercial, professional

or collective use of the article (the warranty

validity will be reduced to six (6) months when

the article is used professionally);

- damage resulting from an inappropriate

packing and shipping of the article;

- all damage caused by modification, repair or

alteration performed by a third party without

written permission by Velleman®.

• Articles to be repaired must be delivered to

your Velleman® dealer, solidly packed

(preferably in the original packaging), and be

completed with the original receipt of purchase

and a clear flaw description.

• Hint: In order to save on cost and time,

please reread the manual and check if the flaw

is caused by obvious causes prior to presenting

the article for repair. Note that returning a

non-defective article can also involve handling

costs.

• Repairs occurring after warranty expiration

are subject to shipping costs.

• The above conditions are without prejudice to

all commercial warranties.

The above enumeration is subject to

modification according to the article (see

article’s manual).

Velleman® service- en kwaliteitsgarantie

Velleman® heeft ruim 35 jaar ervaring in de

elektronicawereld en verdeelt in meer dan 85

landen.

Al onze producten beantwoorden aan strikte

kwaliteitseisen en aan de wettelijke bepalingen

geldig in de EU. Om de kwaliteit te

waarborgen,

ondergaan onze producten op regelmatige

tijdstippen een extra kwaliteitscontrole, zowel

door onze eigen kwaliteitsafdeling als door

externe gespecialiseerde organisaties. Mocht er

ondanks deze voorzorgen toch een probleem

optreden, dan kunt u steeds een beroep doen

op onze waarborg (zie waarborgvoorwaarden).

Algemene waarborgvoorwaarden

consumentengoederen (voor Europese

Unie):

• Op alle consumentengoederen geldt een

garantieperiode van 24 maanden op productie-

en materiaalfouten en dit vanaf de

oorspronkelijke aankoopdatum.

• Indien de klacht gegrond is en een gratis

reparatie of vervanging van een artikel

onmogelijk is of indien de kosten hiervoor

buiten verhouding zijn, kan Velleman®

beslissen het desbetreffende artikel te

vervangen door een gelijkwaardig artikel of de

aankoopsom van het artikel gedeeltelijk of

volledig terug te betalen. In dat geval krijgt u

een vervangend product of terugbetaling ter

waarde van 100% van de aankoopsom bij

ontdekking van een gebrek tot één jaar na

aankoop en levering, of een vervangend

product tegen 50% van de kostprijs of

terugbetaling van 50 % bij ontdekking na één

jaar tot 2 jaar.

• Valt niet onder waarborg:

Page is loading ...

HQ Power VDPCRGB3 User manual

HQ Power VDPCRGB3 User manual

in other languages

Related papers

Other documents