Open-X

™

8M Development Kit

Quick Start Guide

Your use of this document is subject to and governed by those terms and condions in the Intrinsyc Purchase and Soware License Agreement for the Open-X™ 8M Development Kit based on the NXP i.MX 8M Processor, which you or the legal enty you represent, as the case may be,

accepted and agreed to when purchasing an Open-X™ 8M Development Kit from Intrinsyc Technologies Corporaon (“Agreement”). You may use this document, which shall be considered part of the dened term “Documentaon” for purposes of the Agreement, solely in support of

your permied use of the Open-X™ 8M Development Kit under the Agreement. Distribuon of this document is strictly prohibited without the express wrien permission of Intrinsyc Technologies Corporaon and its respecve licensors, which they can withhold, condion or delay in its

sole discreon. Intrinsyc and Open-X are trademarks of Intrinsyc Technologies Corporaon, registered in Canada and other countries. Other product and brand names used herein may be trademarks or registered trademarks of their respecve owners.

6. 3.5 mm audio line-out jack

7. USB Type-A host port

8. USB select switch

9. HDMI video output

10. SOM current sense connector

11. Wi-Fi/BT module

12. MIPI CSI 2 camera connector

13. NXP i.MX 8M SoC

14. Micro SD card slot (on boom)

15. Open-X 8M System on Module

21. Digital audio expansion headers

22. Power, reset, and user buons

9

12

19

24

2

5

10

13

17

16

14

15

Open-X

™

8M Development Kit

Quick Start Guide

3. Connect the Power Adapter to the 12V DC jack, switch the power

switch (3) to the ON position, then press and hold the power button (22)

for approximately 3 seconds. On the LCD or HDMI monitor you will see

the Intrinsyc logo as the board boots up, followed by the OS desktop.

4. Documentation and software