dig-git DG-V0053 Installation guide

“The Solution” to securing beach umbrellas

Instructions

dig-git® Position

From the storage position, rotate the umbrella post one and a half to two turns counterclockwise open to the

dig-git® position, and tighten clockwise until secure then dig a 12-inch-deep hole in the sand.

Anchor Position

Rotate the umbrella post counterclockwise, place the dig-git® in the anchor position, and tighten. Place the

dig-git® in the 12 inch deep hole and cover with beach sand Insert the umbrella and tighten to secure.

Removal Position

To remove the dig-git® from the sand, simply rotate the umbrella post counterclockwise one and a half to two

turns or until it stops. With both hands, gently pull to disengage. The dig-git® will slide easily out of the sand.

Return the dig-git® to storage position and tighten.

This manual is also suitable for