PORTOR LIGHTING PT-CAT2-HW-3CP LED Square Canopy Luminaire User manual

Hello! I've reviewed the provided installation instructions for the PORTOR PT-CAT2 series light fixture, specifically the PT-CAT2-HW-3CP model. This document covers important safety guidelines, wiring procedures, and mounting instructions for both ceiling and pole-pendant options. It also details how to adjust the color temperature and wattage using the switch after removing rubber plug. I'm here to help with any questions you may have about this device and its installation.
What should I do before wiring the fixture?

How do I adjust the color temperature and wattage?

Is it important to have a qualified electrician for the installation?

www.portorlighting.com Specication subject to change without notice 1/2

THIS FIXTURE MUST BE WIRED IN ACCORDANCE WITH THE NATIONAL ELECTRICAL CODE AND APPLICABLE

LOCAL CODES AND ORDINANCES. PROPER GROUNDING IS REQUIRED TO INSURE PERSONAL SAFETY.

CAREFULLY OBSERVE THE GROUNDING PROCEDURE UNDER INSTALLATION SECTION. ALL WORK SHOULD BE

DONE BY A QUALIFIED ELECTRICIAN.

• RISK OF ELECTRIC SHOCK - DISCONNECT POWER AT FUSE OR CIRCUIT BREAKER BEFORE INSTALLING OR

SERVICING.

• RISK OF PERSONAL INJURY - FIXTURE MAY BECOME DAMAGED AND/OR UNSTABLE IF NOT INSTALLED

PROPERLY. TIGHTEN ALL FIXTURE COMPONENTS TO THEIR RECOMMENDED TORQUE VALUES.

• TURN OFF ELECTRICAL POWER AT FUSE OR CIRCUIT BREAKER BOX BEFORE WIRING FIXTURE TO THE POWER

SUPPLY.

• VERIFY THAT SUPPLY VOLTAGE IS CORRECT BY COMPARING IT WITH THE LUMINAIRE LABEL INFORMATION.

• ALL WIRING CONNECTIONS SHOULD BE CAPPED WITH UL APPROVED WIRE CONNECTORS.

• MIN 75°C SUPPLY CONDUCTOR

• AVOID DIRECT EYE EXPOSURE TO THE LIGHT SOURCE WHILE IT IS ON.

• ACCOUNT FOR SMALL PARTS AND DESTROY PACKING MATERIAL, AS THESE

MAY BE HAZARDOUS TO CHILDREN.

• RISK OF BURN. DISCONNECT POWER AND ALLOW FIXTURE TO COOL

BEFORE CHANGING BULB OR HANDING FIXTURE.

(ALWAYS TURN OFF THE POWER SUPPLY FROM MAIN CIRCUIT BREAKER FIRST!)

SAFETY

WARNING

INSTALLATION

READ THESE INSTRUCTIONS COMPLETELY AND CAREFULLY

CAUTION

PT-CAT2 SERIES

PT-CAT2-HW-3CP

INSTALLATION

INSTRUCTIONS

1. Please lay the xture to a flat

surface.

2. Use a correct size screwdriver to

remove the rubber plug.

3. Move the switch left and right

according to the desired color

temperature/wattage.

(Easily flip the switch for desired CCT/Wattage)

Move the switch left and right to get the

desired color temperature/wattage.

ADJUST THE COLOR TEMPERATURE /WATTAGE THROUGH THE SWITCH:

Rubber plug

Screwdriver

STEP OF ADJUSTING COLOR TEMPERATURE AND WATTAGE:

www.portorlighting.com Specication subject to change without notice

INSTALLATION (PAGE 2)

POLE-PENDANT MOUNT:

CEILING MOUNT:

1. Loosen the screw to take off the

mounting plate from the xture.

4. Hook up the xture on the mounting plate.

1. Connecting wires with terminal caps as picture below.

G 3/4” pole

G 3/4” thread

2. Rotating the pole to make it secured with xture.

2. Use screws to lock the mounting

plate on the embedded junction box.

5. Secure the screw. Installation completed.

3. Hang the xture on the ring so as to

connect wires with terminal caps.

2/2

PT-CAT2 SERIES

PT-CAT2-HW-3CP

INSTALLATION

INSTRUCTIONS

(ALWAYS TURN OFF THE POWER SUPPLY FROM MAIN CIRCUIT BREAKER FIRST!)

THE INSTALLATION MUST BE CARRIED OUT BY A QUALIFIED ELECTRICIAN.