Oypla 3083 Owner's manual
- Category
- Flat panel accessories
- Type
- Owner's manual
User Manual
USER MANUAL Model No: 3083
Heavy Duty Dog
Grooming Table
This product is not a toy, and is only to be used for its designated purpose.
Never carry out any alterations or modifications to this product.
This product is intended for indoor use only.
Before using the product, make sure all fastenings are tightly in place and that
everything is in order, and checked periodically by an adult.
Always make sure that the product is on stable ground when in use.
Make sure that the grooming arm is securely held in place when in use.
Keep fingers, loose clothing, and hair away when folding the product.
Clean only with a damp cloth. Do not use strong industrial cleaning substances or
abrasive materials as these will damage the product.
Use the correct fixings as indicated. Do not tighten any of the nuts until the unit is
completely assembled, then finish by tightening all nuts. All nuts must be tightened
before use.
Do not discard any of the packaging until you have checked that you have all of the
parts and fittings required.
If the product is damaged or has any defects, please contact cs[email protected]
USER MANUAL Model No: 3083
Safety Instructions
Notice: Ensure you read and fully understand instructions before use
While every attempt is made to ensure the highest degree of protection in all equipment, we cannot
guarantee freedom from injury. The user assumes all risk of injury due to use. All merchandise is sold on
this condition, which no representative of the company can waive or change.
Assembly Instructions
Parts List:
If you are missing any of the below parts please contact c[email protected]
Please be aware that you will be referring to this parts list throughout the assembly process.
This Carton Includes:
1 x Heavy duty grooming table
2 x Adjustment knob
1 x Support arm
1 x Support harness
How to Set Up:
1. Pull the legs out on the bottom of the table, making sure that they lock into place.
2. Hold the support arm over the circular rise on the top side of the table, making sure the holes align.
Secure this into place using an adjustment knob.
3. Push an adjustment knob into the back of the support arm’s base, only tightening once the arm is at the
required height.
4. Clip the support harness into the top of the support arm, ensuring it is secure and can hold weight so
that it doesn’t come loose whilst in use.
Check over all the adjustment knobs and the supper harness clip before use to ensure that the product.
Imported by Oypla.com LLP, Uxbridge, UB8 2FX
USER MANUAL Model No: 3083
-
1
-
2
-
3
Oypla 3083 Owner's manual
- Category
- Flat panel accessories
- Type
- Owner's manual
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI
