Ridetech 11349572 Operating instructions

Hello! I have reviewed the Installation Instructions for the ridetech Steering Kit 1963-1964 C10. This document details the components included in the kit, such as tie rod adjusters and jam nuts. It also highlights important installation steps, including the use of antisieze compound and ensuring a minimum thread engagement for safety. I'm ready to answer any questions you may have about this steering kit.
What does the Tie Rod Adjuster replace?

How to recognize left-hand threaded side of an adjuster?

What compound should be used when installing the Tie Rod Adjuster?

What is minimum thread engagement for tie rods?

How to ensure proper thread engagement?

1812-482-2932

Installation

Instructions

Recommended Tools

www.ridetech.com

Major Components .....In the box

QTY Part Number Description

2 90000091 Tie Rod Adjuster

2 99800002 5/8”-18 Right Hand Jam Nut

2 99800003 5/8”-18 Left Hand Jam Nut

1 90003043 Idler Arm

2 90003047 Outer Tie Rod End

2 90002918 Inner Te Rod End

Part # 11349572 - 1963-1964 C10 Steering Kit

NOTES:

This Tie Rod Adjuster is designed to take place of the OEM steel sleeve.

One end of the adjuster has a groove cut in it, this is the LEFT HAND threaded side.

When installing the Tie Rod Adjuster, use antisieze compound on the threads.

FOR YOUR SAFETY, THE TIE RODS NEED A MINIMUM 15/16” OF THREAD ENGAGEMENT INTO THE

TIE ROD ADJUSTER. USE THE SIGHT HOLE IN THE SIDE OF THE TIE ROD ADJUSTER TO ENSURE

PROPER THREAD ENGAGEMENT.

REV2 7/30/20