ESL VISION ESL-Vision SL6 18Watt Emergency Driver Installation guide

Hello! I have reviewed the SL6 Emergency Driver Installation Guide. This document provides instructions for installing the emergency driver, which is designed to provide backup power for lighting fixtures. It covers standard 0-10V dimming and non-dimming fixture installations and outlines key features such as a sealed no maintenance battery, and a 24 hr charging requirement. I am ready to answer any questions you have about this product and its installation
What should I do before installation?

Who should perform the installation?

Can I replace the battery?

How long should the battery be charged before normal operation?

Standard Installation to 0–10V Dimmable Fixture

WARNING

1. This emergency driver provides more than one power supply output source. To avoid electric shock,

disconnect power at source prior to installation.

2. The installation should be performed by qualified electricians or lighting technicians.

3. Do not attempt to service the battery. A sealed, no-maintenance battery is used and is not field replaceable.

Replace the entire unit when necessary.

4. The emergency driver requires a constant AC power source of 100–347VAC, 50/60Hz.

5. Battery pack should be charged for 24 hours every 6 months during storage.

6. Battery in this unit may not be fully charged. After electricity is connected to the unit for at least 24 hours

before normal operation.

7. Do not mount near gas or electric heaters. Do not let power supply cords touch hot surfaces.

8. Not for outdoor use.

†Not All Part Numbers DLC Qualified. For a Complete Listing Please Consult the DLC Qualified Products List (QPL).

EMERGENCY DRIVER SERIES

SL6 Installation Guide Page 1 of 2

Non-Dimming Fixture Installation AC Sensor Installation

Dimmer Installation DC Sensor Installation

EMERGENCY DRIVER SERIES

SL6 Installation Guide Page 2 of 2