2. Computers & electronics
  3. TVs & monitors
  4. Wall & ceiling mounts accessories
  5. Chief
  6. PSB2043

Chief PSB2043 Installation guide

  • Hello, I'm your chat assistant. I've reviewed the installation instructions for the Chief PSB-2043 Plasma Display Mounting Bracket. The document details the necessary steps for assembly, emphasizing the fragile nature of plasma displays and the need for secure mounting to support up to 175 lbs. I'm ready to answer any questions you may have about this bracket.
  • What is the maximum weight the mount can support?
    What type of screws are used to secure the mounting buttons to the upright brackets?
    What is the purpose of the nylon spacers?
INSTALLATION INSTRUCTIONS
CHIEF MANUFACTURING INC.
1-800-582-6480 952-894-6280 FAX 952-894-6918
8401 EAGLE CREEK PKWY, STE. 700
SAVAGE, MINNESOTA 55378 USA
8804-000210 RevE
2010 Chief Manufacturing
www.chiefmfg.com
4/10
ALL COMPONENTS MUST BE SECURELY FASTENED TO A
STRUCTURAL MEMBER CAPABLE OF SUPPORTING 4
TIMES THE COMBINED WEIGHT OF ALL COMPONENTS
PLUS THE EQUIPMENT BEING MOUNTED. IF IT CANNOT
SUPPORT THIS WEIGHT, THE STRUCTURE MUST BE
REINFORCED.
THE MAXIMUM WEIGHT TO BE INSTALLED ON THE
MOUNT IS 175 POUNDS
(79.38 KG).
PSB-2043
PLASMA DISPLAY MOUNTING BRACKET
Prior to assembly, unpack carton completely and verify contents.
(2)
Plasma Interface Bracket Uprights
(2)
Plasma
Interface Brackets Upper and Lower
(4)
Mounting Buttons
-
(4)
5/16
-
18 x 1” Button Head Cap Screw
(4)
5/16
-
18 x ½” Button Head Cap Screw
(4)
5/16
-
18 Nylock Nut
(6)
½” Nylon Spacer
(6)
M8 x 25 mm Philips Head Cap Screws
(1)
3/16” Allen
Key
(6)
M8 x 30 mm Philips Head Cap Screws
BEFORE PROCEEDING, READ INSTALLATION INSTRUCTIONS COMPLETELY
PLASMA DISPLAYS ARE EXTREMELY FRAGILE.
1. Using a 516-18 x 1” button head cap screw inserted from the front of the mounting button, secure
mounting button, with chamfered hole of mounting button (larger surface) facing bracket, to upright
brackets (four places) (see Figure 2). Make sure the bends on interface bracket face away from the
button.
CAUTION!
WARNING!
Figure 1
Figure 2
Installation Instructions PSB-2043
2
2. Attach the uprights to the upper and lower brackets using the 5/16-18 x ½” BHCS (see
Figure 3 and Figure 4). Do not fully tighten until the brackets are attached to the screen.
3. Place four or six Nylon spacers over the mounting holes on the back of the screen and attach the
brackets using the appropriate M8 screws for your screen (see Figure 5 & Figure 6). After the
brackets are tightened in place, fully tighten the 5/16-18 x ½” BHCS’s to the uprights.
NOTE: If display only has four mounting holes on the back, use outer
four holes on bracket to attach bracket to display.
4. With the aid of another person, lift your display up to the Chief Mount, aligning buttons of mounting
brackets with slots in the Chief Mount.
5. Lower safety catch on the Chief Mount to secure your display, making sure catch is completely
engaged.
Figure 3 Figure 4
Figure 5 Figure 6
/