2. Computers & electronics
  3. TVs & monitors
  4. Wall & ceiling mounts accessories
  5. Premier Mounts
  6. PP-5A

Premier Mounts PP-5A Operating instructions

  • Hello! I've reviewed the assembly instructions for the PREMIER MOUNTS PP-5 and PP-5A ceiling mounts. This document provides details on installation, safety, and key features such as the locking screw for PP-5 and cable access along with 360° rotation for the PP-5A. I'm ready to answer your questions about these mounts.
  • What is the minimum ceiling support requirement?
    What is used to secure the pipe in PP-5 mount?
    What is specific about cable management in PP-5A?
PP-5, -5A
Installation Instructions Page - 1 -
PP-5 and PP-5A Assembly Instructions
PP-5
NOTE: The ceiling should be capable of supporting a weight of at least five times the projector or
monitor weight. If it cannot, the ceiling must be reinforced. Proper installation procedure by
qualified personnel as outlined in the installation instructions must be adhered to. Failure to do so
could result in serious personal injury.
1. Install the PP-5 securely to the ceiling structure in accordance with proper commercial standards. Use
suitable hardware depending on the installation requirements (Figure 1).
2. Install the desired length of 1-1/2” diameter NTP pipe with threaded ends for the PP-5.
3. Tighten the ¼” x 20 x 1/2” locking screw to the PP-5 to secure the pipe so it will not swivel.
NOTE: For more adjustable suspension the PP-5 can be mated directly to our ASP-2446 suspension
Figure 1
Locking Screw
PP-5, -5A
Page - 2 - Installation Instructions
PP-5A
WARNING: The ceiling should be capable of supporting a weight of at least five (5) times the weight
intended to hang from the PP-5A, if it cannot, the ceiling must be reinforced. Proper
installation procedure by qualified personnel as outlined in the installation instructions must
be adhered to. Failure to do so could result in serious personal injury.
1. Install the PP-5A to the ceiling structure according to commercial standards.
2. Use (commercially available) suitable hardware depending on the installation requirements.
3. See Figure 2 for cable access and 360º rotation.
4. Tighten the M6 x 12mm screws to secure the pipe.
Figure 2
(Commercially available)
suitable hardware
1-1/2” coupling
Ceiling structure
(See warning)
M6 x 12 Phillips
screws
1-1/2” (NTP)
Threaded pipe
(Not supplied)
Cable Access
/