Installation:
• Both clamps should be installed with ¼’’ bolts, washers (under the bolt head) and
nuts (not provided).
• One way to install Quick Fist Clamps is to use rivet nuts, which allow you to rivet
a nut into a “blind” hole (i.e. a hole where it is difficult to attach a nut).
• The clamp which holds the Butt should be installed first. It can be installed with
the strap on either side of the weapon. Then install the forend or barrel clamp.
Note: The Forend Clamp must be mounted with bolts to effectively hold a barrel.
Trying it in your hand will not work, as the base must be flat to obtain a tight grip
around the barrel.
ITEM #01887
MADE IN USA
End of the Road, Inc • 2212 Dortch Ave. • Nashville, TN 37210, USA
(615) 828-2600 • www.endroad.com
Butt and Forend mount Butt and Barrel Mount Butt and Forend Mount
Forend
Clamp
Barrel
Clamp
These bolt holes are
used for vertical
mounting
Either of these sets of
bolt holes are used for
horizontal mounting
Stock
Clamp
Installation:
• Both clamps should be installed with ¼’’ bolts, washers (under the bolt head) and
nuts (not provided).
• One way to install Quick Fist Clamps is to use rivet nuts, which allow you to rivet
a nut into a “blind” hole (i.e. a hole where it is difficult to attach a nut).
• The clamp which holds the Butt should be installed first. It can be installed with
the strap on either side of the weapon. Then install the forend or barrel clamp.
Note: The Forend Clamp must be mounted with bolts to effectively hold a barrel.
Trying it in your hand will not work, as the base must be flat to obtain a tight grip
around the barrel.
ITEM #01887
MADE IN USA
End of the Road, Inc • 2212 Dortch Ave. • Nashville, TN 37210, USA
(615) 828-2600 • www.endroad.com
Butt and Forend mount Butt and Barrel Mount Butt and Forend Mount
Forend
Clamp
Barrel
Clamp
These bolt holes are
used for vertical
mounting
Either of these sets of
bolt holes are used for
horizontal mounting
Stock
Clamp