TANDBERG MPS 200 User manual

Brand
TANDBERG
Model
MPS 200
Category
Gateways/controllers
Type
User manual

This manual is also suitable for

D13695.01 Page 1
MPS 200 Installation
Unpacking
User manual (on CD)
Ethernet/LAN cables
Power cables
Accessories
Connecting Cables (front)
Ethernet Switch
10/100 BASE T
USB1
COM1
ABT
RST
HOLD
CPU FAIL
USB0
IP
D13695.01 Page 2
Conguration
To do the initial conguration of the IP-address of the System Controller Board and Media Board through the
Front Panel, follow the instructions below:
1. Switch on the TANDBERG MPS 200 by pressing the power switch button on the back to ‘1’.
The system is ready for conguration when the Power and Active LED’s on the Media Processing Boards
are green and the menu appears at the LCD.
2. Press the up arrow button to get to the start menu.
3. Press the conrm button ‘V’ to start Parameter Cong.
4. Press the conrm button ‘V’ to start the SC IP Cong.
5. Use the arrow buttons to set the following parameters:
• IP: Denes the static IP address of the System Controller Board
• SNM: Denes the static IP Subnet Mask for the network
• GW: Denes the static IP Gateway address
• IF Speed: Denes the Ethernet speed
6. Use the arrow buttons to select Media IP Cong and press the conrm button ‘V’.
7. Press the conrm button ‘V’ to start the Media 1 IP Cong.
8. Use the arrow buttons to set the following parameters:
• IP: Denes the static IP address of the Media board
• SNM: Denes the static IP Subnet Mask for the network
• GW: Denes the static IP Gateway address
• IF Speed: Denes the Ethernet speed
9. Restart the TANDBERG MPS 200.
Accessing the TANDBERG MPS 200
After conguring the IP-address of the System Controller Board, you may access the TANDBERG MPS 200 by
entering the IP-address of the System Controller Board in a standard WEB-browser. You will then be asked to
enter a password. It is not necessary to enter ‘User Name’. The default password for the TANDBERG MPS 200
is ‘TANDBERG’. Remember that the password is case sensitive.
Connecting Cables (rear)
Power cable and power switch at the rear of the MPS 200.
Power
SERIAL 3/4
ENET 2 ENET 1
COM 1
KB/MS
  • Page 1 1
  • Page 2 2

TANDBERG MPS 200 User manual

Brand
TANDBERG
Model
MPS 200
Category
Gateways/controllers
Type
User manual
This manual is also suitable for
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents