Symmons 4403-STN Installation guide

Symmons
Brand
Symmons
Model
4403-STN
Category
Sanitary ware
Type
Installation guide

This manual is also suitable for

4403-TRM, 4405-TRM, 4406-TRM
Carrington
™
Trim Series
Operation & Maintenance Manual
Model Numbers Specifications
4403-TRM Valve Trim with Hand Shower
4405-TRM Shower Trim with Hand Shower
4406-TRM Tub/Shower Trim with Hand
Shower
Tub/shower trim with hand shower and lever handle
includes wall connection, cradle for hand shower
mounting, in-line vacuum breaker, exible metal
hose, non-diverter tub spout, 3 mode hand shower and
3 mode showerhead with standard 2.5 gpm (9.5 L/min)
ow restrictor. Shower trim with hand shower and lever
handle includes all of the above less non-diverter tub
spout. Valve trim with hand shower and lever handle
includes all of the above less non-diverter tub spout
and 3 mode showerhead. Components made from
metal and nonmetallic materials plated in standard
polished chrome nish.
Modifications Warranty
-1.5 1.5 gpm (5.7 L/min) flow restrictor
-2.0 2.0 gpm (7.6 L/min) flow restrictor
-442HSB 30" slide bar in place of wall cradle on
hand shower units
-CRP Cross handle in place of white
insert handle
-LAM Metal finish insert handle
-STN Satin nickel finish
Limited Lifetime - to the original end purchaser in
consumer installations.
5 Years - for commercial installations.
Refer to www.symmons.com/warranty for complete
warranty information.
Note: Append appropriate -sufx to model number.
Symmons Industries, Inc. ■ 31 Brooks Drive ■ Braintree, MA 02184 ■ (800)796-6667 ■ Fax: (800)961-9621
©2014 Symmons Industries, Inc.
■
www.symmons.com
■
[email protected]
■
ZV-3057 REV 0 09/03/14
2
Dimensions
Symmons Industries, Inc. ■ 31 Brooks Drive ■ Braintree, MA 02184 ■ (800)796-6667 ■ Fax: (800)961-9621
©2014 Symmons Industries, Inc.
■
www.symmons.com
■
[email protected]
■
ZV-3057 REV 0 09/03/14
Measurements
A Ø 2 5/8", 67 mm
B 9 1/4", 235 mm
C 1/2" NPT
D 2 1/8", 54 mm
E 1/2", 13 mm
F
Male 1/2" IPS thread must be
recessed 1/4" from nished
wall
G 6", 152 mm right or left
H 77", 1956 mm
I Ø 7 1/2", 191 mm
J Ø 4 5/8", 117 mm
K 8", 203 mm
L 2 7/8", 73 mm
M 4 3/8", 111 mm
N Ø 2 5/8", 67 mm
O
32", 813 mm (4306-TRM)
45", 1143 mm
(4303-TRM, 4305-TRM)
P 12", 305 mm
Q 3 1/8", 79 mm
R 2 3/4", 70 mm
S 1/2" NPT
T 1/2", 13 mm
U
(Rough in)
2" ± 1/2", 51 mm ± 13 mm
V 6 1/2", 165 mm
Notes:
1) All dimensions measured from nominal rough-in (see U as reference).
2) Dimensions are subject to change without notice.
AA
D
D
J
J
I
I
N
N
O
O
P
P
H
H
B
B
C
C
F
F
M
M
K
K
Q
Q
R
R
L
L
U
U
V
V
E
E
T
T
S
S
G
G
Floor
Floor
3
Parts Breakdown
Symmons Industries, Inc. ■ 31 Brooks Drive ■ Braintree, MA 02184 ■ (800)796-6667 ■ Fax: (800)961-9621
©2014 Symmons Industries, Inc.
■
www.symmons.com
■
[email protected]
■
ZV-3057 REV 0 09/03/14
Replacement Parts
Item Description Part Number
A
S
Vacuum Breaker
60" Hose
EF-104
B Wall Elbow EF-105
C Showerhead 442SH
D Shower Arm 304
E
F
G
H
Set Screw
Handle
Flange
O-ring
DF-28-LPO
I Lock Nut T-20-PL
J Washer 40B-PL
K Dome Cover DF-11
L
M
Mounting Screws
Escutcheon
DF-14
N
O
P
Cradle
Cradle Mounting Screws
Cradle Mounting Plate
EF-106
Q Tub Spout 063
R Hand Shower 442W
T Escutcheon Plate 7.5-ETCH
Notes:
1) Append -STN to part number for satin nickel nish.
2) Append -1.5 or -2.0 to showerhead or hand shower
for low ow.
Required for Installation
Adjustable wrench
Phillips head screwdriver
Allen wrench (1/8")
Plumber tape
R
L
A
B
M
S
M
O
P
C
E
G
I
F
H
J
D
N
Q
K
K
E
G
I
F
H
J
T
L
4
Installation
Symmons Industries, Inc. ■ 31 Brooks Drive ■ Braintree, MA 02184 ■ (800)796-6667 ■ Fax: (800)961-9621
©2014 Symmons Industries, Inc.
■
www.symmons.com
■
[email protected]
■
ZV-3057 REV 0 09/03/14
Note:
For valve body installation, please
see valve body installation guides.
1)
Install shower escutcheon (M)
and
escutcheon plate (T) to shower
valve. Secure with two screws (L).
2) Install diverter escutcheon (M) to
diverter valve
.
Secure with two
screws (L).
3) Install dome covers (K) and
washers (J) to valves and secure
with lock nuts (I).
4) Install o-rings (H), anges (G),
and handles (F) to valves and
secure with screws (E).
Note: Handles should be facing the
6 o'clock position.
5)
Install tub spout (Q) to pipe tting.
Turn clockwise to secure.
6) Install wall elbow
(B)
to pipe tting.
Tighten set screw to secure.
7) Place mounting plate
(P)
in
position, mark and drill 1/8" pilot
holes into stud.
1
2
3
L
T
M
1
2
L
M
1
2
Q
1
2
B
1
2
P
1
1
2
K
I
J
K
I
J
1
1
2
E
G
F
H
E
G
F
H
5
Installation
Symmons Industries, Inc. ■ 31 Brooks Drive ■ Braintree, MA 02184 ■ (800)796-6667 ■ Fax: (800)961-9621
©2014 Symmons Industries, Inc.
■
www.symmons.com
■
[email protected]
■
ZV-3057 REV 0 09/03/14
Option:
Place mounting plate
(P)
in
position, mark and drill 3/16" holes
into wall. Install anchors.
8) Remove cover of hand shower
cradle
(N)
. Install cradle and
mounting plate
(P)
. Secure with
three screws
(O)
. Replace cover
on hand shower cradle.
9) Attach shower arm
(D)
to vertical
shower pipe turning clockwise to
tighten.
10) Install showerhead
(C)
to shower
arm
(D)
turning clockwise to
tighten.
11) Attach large end of hand shower
hose (S) to hand shower (R).
Attach small end of hand shower
hose (S) and gasket to in-line
vacuum breaker (A). Connect
in-line vacuum breaker to wall
elbow (B). Turn clockwise to
tighten.
4
3
P
O
N
2
1
3
1
4
2
S
R
A
S
B
1
2
C
D
2
1
D
1
3
2
P
6
Care and Cleaning
1) Clean nished trim area with a soft cloth using mild soap and water or a non-abrasive cleaner and then quickly rinse
with water.
Troubleshooting Chart
Problem Cause Solution
Finish is spotting. Elements in water supply may cause
water staining on nish.
Clean nished trim area with a soft
cloth using mild soap and water or a
non-abrasive cleaner and then
quickly rinse with water.
Symmons Industries, Inc. ■ 31 Brooks Drive ■ Braintree, MA 02184 ■ (800)796-6667 ■ Fax: (800)961-9621
©2014 Symmons Industries, Inc.
■
www.symmons.com
■
[email protected]
■
ZV-3057 REV 0 09/03/14
1) Turn shower handle counterclockwise approximately
1/4 turn to put valve in cold position.
2) Turn shower handle counterclockwise approximately
1/2 turn to put valve in warm position.
3) Turn shower handle counterclockwise approximately
3/4 turn to put valve in hot position.
1) Diverter handle facing straight down is for diverter
function 1.
2) 4403-TRM & 4405-TRM: Turn diverter handle
counterclockwise one full revolution for diverter
function 2.
4406-TRM: Turn diverter handle counterclockwise 1/4
turn for diverter function 2.
3) 4406-TRM: Turn diverter handle counterclockwise 3/4
turn for diverter function 3.
Operation
Temperature Control Diverter Control
4405-TRM 4406-TRM
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4
  • Page 5 5
  • Page 6 6

Symmons 4403-STN Installation guide

Symmons
Brand
Symmons
Model
4403-STN
Category
Sanitary ware
Type
Installation guide
This manual is also suitable for
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents